108: Difference between revisions

From TekWiki
Jump to navigation Jump to search
No edit summary
No edit summary
(17 intermediate revisions by 2 users not shown)
Line 1: Line 1:
The Tektronix 108 is a 1ns-risetime pulse generator.
[[File:Tek 108 front.jpg|thumb|350px|right]]
It is the predecessor of the  
The '''Tektronix 108''' is a 1 ns rise-time pulse generator  
more complex and faster [[109]].
intended for calibration of the [[517]].
Repetition rate of the 108 is 240 pps and the  
 
maximum pulse amplitude is 10Vpk into 50 Ohm load.  
It is the predecessor of the more complex and faster [[109]].
The price in July 1959 was $125.
Repetition rate of the 108 is 240 Hz and the maximum pulse amplitude is 10 V<sub>p</sub> into a 50 Ω load.  
It uses a [[mercury switch]] and [[selenium rectifiers]]. The output is through an [[N connector]].
 
The price in July 1959 was $125.
 
Referring to the output network photo below, current flows in from the left through the 1 kΩ resistor and charges the four red 0.1 μF capacitors in parallel.
When the mercury switch (terminals visible at lower right) closes, the capacitors are suddenly connected to the output load of the pulse generator, causing a sharp step in the output voltage.  The starting voltage of the step is typically 0 V.  The final voltage is adjustable, both in polarity and magnitude.  The range is approximately -10 V to 10 V.
 
* [http://w140.com/tek_108.pdf Tektronix 108 Manual (PDF)]


<gallery>
<gallery>
Image:Tek 108 front.jpg
Tek 108 front.jpg | Front view
Image:Tek 108 left.jpg
Tek 108 schem.png | Schematic
Image:Tek 108 right.jpg
Tek 108 left.jpg|Left view, mercury switch
Tek 108 right.jpg | right view, selenium recitifier
Tek 108 output network.jpg | Output network, rear of N connector
Tek 108 cat.jpg|Page 190 in the 1959 Catalog
Tek 108 mercury switch.png | Mercury switch
</gallery>
</gallery>
[[Category:Pulse generators]]
[[Category:Introduced in 1959]]

Revision as of 06:17, 6 July 2018

The Tektronix 108 is a 1 ns rise-time pulse generator intended for calibration of the 517.

It is the predecessor of the more complex and faster 109. Repetition rate of the 108 is 240 Hz and the maximum pulse amplitude is 10 Vp into a 50 Ω load. It uses a mercury switch and selenium rectifiers. The output is through an N connector.

The price in July 1959 was $125.

Referring to the output network photo below, current flows in from the left through the 1 kΩ resistor and charges the four red 0.1 μF capacitors in parallel. When the mercury switch (terminals visible at lower right) closes, the capacitors are suddenly connected to the output load of the pulse generator, causing a sharp step in the output voltage. The starting voltage of the step is typically 0 V. The final voltage is adjustable, both in polarity and magnitude. The range is approximately -10 V to 10 V.