1401: Difference between revisions
(separate out the 1401A from the 1401 page, prep for large edit.) |
m (in progress) |
||
| Line 1: | Line 1: | ||
[[Image:Tek1401a-front.JPG|thumb|600px|right|Tektronix 1401A Spectrum Analyzer Module]] | |||
It covers the frequency range from 1MHz to 500MHz. | It covers the frequency range from 1MHz to 500MHz. | ||
It uses an external oscilloscope, | It uses an external oscilloscope, | ||
| Line 5: | Line 6: | ||
as a display. | as a display. | ||
The 1401A can be operated on batteries or 12V or wall power. | The 1401A can be operated on batteries or 12V or wall power. | ||
See TekScope January 1972 pages 14-15 for some servicing notes that | |||
Tek wrote after the manual was published. | |||
There is one tunnel diode found in the external trigger circuit. | |||
It is a 152-0402-00, a 2mA, 25pF tunnel diode in a DO-17 package. | |||
It's only necessary if you use the external trigger input. | |||
The input attenuator is a fairly custom part due to the IF gain pot | |||
that is concentric with the RF atten control. Dissassembly of the | |||
attenuator is easy after removing it from the 1401A. Note that the | |||
IF gain pot is removed via two allen setscrews. To bench test the | |||
attenuator with DC, use a 50 ohm terminator | |||
* [[List of manuals that are needed|Manual needed]] | * [[List of manuals that are needed|Manual needed]] | ||
Revision as of 21:57, 11 October 2014
It covers the frequency range from 1MHz to 500MHz. It uses an external oscilloscope, typically a 323 or 324, as a display. The 1401A can be operated on batteries or 12V or wall power.
See TekScope January 1972 pages 14-15 for some servicing notes that Tek wrote after the manual was published.
There is one tunnel diode found in the external trigger circuit. It is a 152-0402-00, a 2mA, 25pF tunnel diode in a DO-17 package. It's only necessary if you use the external trigger input.
The input attenuator is a fairly custom part due to the IF gain pot that is concentric with the RF atten control. Dissassembly of the attenuator is easy after removing it from the 1401A. Note that the IF gain pot is removed via two allen setscrews. To bench test the attenuator with DC, use a 50 ohm terminator