The Tektronix 321 is a very compact single-trace, single-timebase portable oscilloscope that is almost completely solid state. It was introduced on April 8th, 1960.
The 321 includes several germanium bipolar transistors, which are a known reliability problem.
|Bandwidth||5 MHz (321) / 6 MHz (321A)|
|Rise time||70 ns (321) / 64 ns (321A)|
|Sweep||0.5 μs/Div to 0.5 s/Div, 1—2—5, ×5 magnifier (i.e. to 50 ns/Div)|
|Deflection||10 mV/Div to 20 V/Div|
|Input impedance||1 MΩ // 35 pF|
|Calibrator||0.5 Vp-p, about 2 kHz|
|CRT||T3210 or T3211-31 or 154-433, P31 phosphor, 10 × 6 Div. @ 6.25 mm (0.25"), 4 kV acceleration|
|AC Power||90—136 V or 180—272 V, 20 W|
|DC Power||11.5—35 V, 8.5 W min., 24.5 W max., 700 mA current typ.|
|Battery||Ten size "D" NiCd cells, runtime 5 h (4 Ah cells), 3 h (2.5 Ah cells), charge time 16 h|
|Dimensions||21.67 cm × 14.6 cm × 40 cm (8.5" × 5.75" × 16")|
|Weight||unknown, about 5 kg|
External Power Connector
Douglas W Jones wrote:
I've got a Tektronix 321 scope (serial number 001917) that I need to run from an external DC supply. The problem is, I have only the line cord, and not the DC cord. The power input plugs on the scope are obviously custom, long predating the standard IEC plug everyone uses today.
So I improvised. The pin spacing for the 3-pin DC input plug is very close to the spacing of Molex 6, 9 and 12-pin plugs, and the pin diameter is not too much larger than Molex uses. So, I picked up a 6-pin Molex housing and 3 female molex pins, and then cut the housing down to 4 pins (using my pocket knife).
I used an old IEC cord for the DC input wires, with the plugs cut off both ends. I attached the wires on one end to the molex pins and pushed them into the housing, then jammed to housing down onto the Tektronix connector (this flared the female Molex pins to fit the Tektronix pins. The other end of the DC power cord got banana plugs to fit the output posts of my DC power supply.
The net result works fine, plugs and unplugs nicely, and unlike other power supply solutions I've seen, involves no changes to the scope.
Added note: My bench supply has an analog Ammeter on it. The starting surge of the 321 is about 1.5 amps, perhaps 2, tapering down to 0.7 amps in under a second. It seems to draw a steady 0.7A regardless of what you're doing with it. The current drain doesn't change when you vary the supply from 12 to 18V — this is because the 321 uses a linear regulator.