4S2: Difference between revisions

From TekWiki
Jump to navigation Jump to search
No edit summary
Line 27: Line 27:
Tek 4s2a sampler.png|42SA sampler schematic
Tek 4s2a sampler.png|42SA sampler schematic
Tek 4s2a pulse gen.png|42SA pulse generator schematic
Tek 4s2a pulse gen.png|42SA pulse generator schematic
Tek 4s2 avalanche pulse components.jpg|4S2 Avalanche Pulse Generator
Tek 4s2 avalanche pulse1.jpg|4S2 Avalanche Pulse Generator
Tek 4s2 avalanche pulse2.jpg|4S2 Avalanche Pulse Generator
Tek 4s2 avalanche pulse4.jpg|4S2 Avalanche Pulse Generator
Tek 4s2 sampler.jpg|4S2 Sampler
Tek 4s2 sampler.jpg|4S2 Sampler
Tek 4s2 sampler2.jpg|4S2 Sampler
Tek 4s2 sampler2.jpg|4S2 Sampler
Line 37: Line 41:
Tek 4s2 dual-trace outside.jpg|Dual Trace
Tek 4s2 dual-trace outside.jpg|Dual Trace
Tek 4s2 dual-trace components.jpg|Dual Trace
Tek 4s2 dual-trace components.jpg|Dual Trace
Tek 4s2 rear.jpg|4S2 Rear
</gallery>
</gallery>


[[Category:661 plugins]]
[[Category:661 plugins]]
[[Category:Sampling plugins]]
[[Category:Sampling plugins]]

Revision as of 21:23, 14 December 2017

Template:Plugin Sidebar 2 The Tektronix 4S2 is a two-channel sampling vertical plug-in for the 661. Signals enter the 4S2 through GR-874 connectors on the front panel. Unlike the 4S1, the 4S2's signal path does not contain a delay line between the input connector and the sampler. This has the advantage of maintaining higher pulse fidelity and thus higher bandwidth. It has the disadvantage of making it impossible to see the leading edge of the triggering event unless a pre-trigger is used.

The 4S2 uses a four-diode sampling bridge. The 4S2A uses a two-diode sampling bridge. This design change is discussed in the 4S2A Engineering Spec document linked below.

Pictures