5000 Series plug-in interface: Difference between revisions
Jump to navigation
Jump to search
m (I knocked up a script to re-map the table.) |
m (Slipped up on a row) |
||
| Line 66: | Line 66: | ||
|- | |- | ||
! 11 | ! 11 | ||
| | | Load stop <ref name="note 1">[[5223]] / [[5B25N]]</ref> || Sample pulse <ref name="note 1" /> | ||
|- | |- | ||
! 10 | ! 10 | ||
Revision as of 11:09, 9 July 2023
Tektronix 5000 series oscilloscope mainframes have two vertical plug-in slots, and one horizontal plug-in slots.
The interconnect on either slot type is a 56-pin PCB edge connector.
Looking into the mainframe from the front panel, "A" pins are left of the connector centerline and "B" are on the right. Pins are numbered from 1 at the bottom to 28 on the top.
| Pin | B side Function |
A side Function |
|---|---|---|
| 28 | Ch. 1 Row | Ch. 1 Col |
| 27 | TS4 | TS1 |
| 26 | TS9 | TS8 |
| 25 | TS2 | TS3 |
| 24 | Ch. 2 Row / Sweep rate | Ch. 2 Col |
| 23 | TS6 | TS5 |
| 22 | TS10 | TS7 |
| 21 | −30 V | |
| 20 | Chop activate | |
| 19 | Display chop | 100 μs/div detect |
| 18 | Display on | Chop sense |
| 17 | Single sweep reset | Lockout A sweep |
| 16 | Trace separation | Lockout B sweep |
| 15 | ALT drive | A sweep |
| 14 | Clean GND Return | Clean GND Return |
| 13 | −plugin signal | +plugin signal |
| 12 | Single-sweep mode | |
| 11 | Load stop [1] | Sample pulse [1] |
| 10 | Z Axis B Sweep | A gate |
| 9 | Intensify | Z Axis A Sweep |
| 8 | ||
| 7 | −plugin signal | +plugin signal |
| 6 | −15 V [54xx only!] | +15 V [54xx only!] |
| 5 | −30 V | +30 V |
| 4 | Left trig in (V) | Trig out (H) / Right trig in (V) |
| 3 | Line trigger | |
| 2 | +5 V | Utility GND |
| 1 | +38 V unreg | +200 V |
Notes
Pin group function legend
Plugin power & ground HF signals Readout system signals (5400 series only)