571: Difference between revisions

From TekWiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 8: Line 8:
manuals=
manuals=
* [http://w140.com/tek_571.pdf Tektronix 571 Operator's Manual (PDF)]
* [http://w140.com/tek_571.pdf Tektronix 571 Operator's Manual (PDF)]
* "Instruction Manual" (Operator's + Service) or "Service Manual" needed
* [[Media:070-7722-00.pdf|Tektronix 571 Service Manual (PDF)]]
[[Category:Manual needed]]
}}
}}
The '''Tektronix 571''' is a [[:Category:Curve tracers|curve tracer]].
The '''Tektronix 571''' is a [[:Category:Curve tracers|curve tracer]].
Line 44: Line 43:
Tek 571 npn.jpg
Tek 571 npn.jpg
</gallery>
</gallery>


[[Category:Curve tracers]]
[[Category:Curve tracers]]

Revision as of 05:37, 31 August 2020

{{{manufacturer}}} 
Curve tracer
Tektronix 571 Curve tracer

Produced from 1989 to 1995

Manuals
(All manuals in PDF format unless noted otherwise)
Manuals – Specifications – Links – Pictures

The Tektronix 571 is a curve tracer. It can show the characteristic curves of PNP and NPN bipolar transistors, both N- and P-channel FETs, diodes (including Zener types), and SCRs. It is a microprocessor-controlled device, and user interaction is done through navigation keys. A typical sweep run takes about five seconds. It has a parallel printer output that can print graphics on Epson-protocol dot-matrix printers.

One nice feature of the 571 is its ability to store a set of reference curves, which are displayed as a background for subsequent measurement runs. This makes comparison and matching between devices easy.

The 571 has a well-designed field of parallel-connected sockets to accommodate many different semiconductor package types. Details can be seen in the photographs below.

Because the nature of electronic component testing involves exposing components to sometimes hazardous voltages and operating conditions, at certain settings the 571 will refuse to start a measurement cycle until the user lowers the built-in hinged plastic shield over the socket area. This is to protect the user from both high voltage and high-velocity flying debris in the event of a catastrophic component failure during a test run. The shield is made of a thick high-impact plastic, and the 571 has an internal microswitch so its firmware knows if the shield is in the up or down position.

Specifications

please add

Pictures