7D20: Difference between revisions
(DACs and roll mode) |
No edit summary |
||
| Line 1: | Line 1: | ||
The Tektronix 7D20 is a two-channel digitizing plug-in for 7000-series mainframes. It is a triple-width plug-in and provides both vertical and horizontal signals to the scope. The 7D20 uses an analog shift register for high-speed signal acquisition, and then digitizes the stored analog signal at a lower speed. This allowed the 7D20 to capture single-shot events at 40Msamp/sec even though exceeded the speed of ADCs of the time. The 7D20 can digitally store waveforms and has GPIB. A microprocessor in the plug-in controls most of its functions. The analog waveforms that are sent to the 7000-series mainframe are generated by vertical and horizontal DACs. They are DACs outputs can be calibrated for scaling and shift so that signals are accurately displayed on the oscilloscope screen. The 7D20 has a "roll" mode that emulates a paper roll chart. It is as if the waveform is being drawn by a pen on the right side of the screen while the paper is being moved to the left at a constant rate. No equivalent to "roll" exists in analog scopes. The Tektronix 2212 also has this feature. | The Tektronix 7D20 is a two-channel digitizing plug-in for 7000-series mainframes. It is a triple-width plug-in and provides both vertical and horizontal signals to the scope. The 7D20 uses an analog shift register for high-speed signal acquisition, and then digitizes the stored analog signal at a lower speed. This allowed the 7D20 to capture single-shot events at 40Msamp/sec even though exceeded the speed of ADCs of the time. The 7D20 can digitally store waveforms and has GPIB. A microprocessor in the plug-in controls most of its functions. The analog waveforms that are sent to the 7000-series mainframe are generated by vertical and horizontal DACs. They are DACs outputs can be calibrated for scaling and shift so that signals are accurately displayed on the oscilloscope screen. The 7D20 has a "roll" mode that emulates a paper roll chart. It is as if the waveform is being drawn by a pen on the right side of the screen while the paper is being moved to the left at a constant rate. No equivalent to "roll" exists in analog scopes. The Tektronix 2212 also has this feature. The manual is on BAMA. | ||
Revision as of 14:16, 2 May 2009
The Tektronix 7D20 is a two-channel digitizing plug-in for 7000-series mainframes. It is a triple-width plug-in and provides both vertical and horizontal signals to the scope. The 7D20 uses an analog shift register for high-speed signal acquisition, and then digitizes the stored analog signal at a lower speed. This allowed the 7D20 to capture single-shot events at 40Msamp/sec even though exceeded the speed of ADCs of the time. The 7D20 can digitally store waveforms and has GPIB. A microprocessor in the plug-in controls most of its functions. The analog waveforms that are sent to the 7000-series mainframe are generated by vertical and horizontal DACs. They are DACs outputs can be calibrated for scaling and shift so that signals are accurately displayed on the oscilloscope screen. The 7D20 has a "roll" mode that emulates a paper roll chart. It is as if the waveform is being drawn by a pen on the right side of the screen while the paper is being moved to the left at a constant rate. No equivalent to "roll" exists in analog scopes. The Tektronix 2212 also has this feature. The manual is on BAMA.