Cam switches: Difference between revisions
No edit summary |
No edit summary |
||
| Line 21: | Line 21: | ||
Cam-04.jpg | 7D15 double-sided switch, bottom-side contacts | Cam-04.jpg | 7D15 double-sided switch, bottom-side contacts | ||
Cam-05.jpg | 7D15 double-sided switch, through-board pins | Cam-05.jpg | 7D15 double-sided switch, through-board pins | ||
Tek cam switch cam.jpg | |||
</gallery> | </gallery> | ||
[[Category:Repair issues]] | [[Category:Repair issues]] | ||
[[Category:Electromechanical components]] | [[Category:Electromechanical components]] | ||
Revision as of 17:16, 12 May 2017
Cam switches are used in many Tek instruments, particularly in 7000-series plug-ins, but also in TM500 equipment and 400-series portable scopes.
The lobes on the rotary cam encode the lookup table of which contacts should be open or closed in each rotational position of the shaft, which is typically rotated by a knob on the front panel of the instrument. A benefit of this design is low parasitics compared to traditional rotary wafer switches.
For cleaning, Tek recommends swiping paper soaked in isopropyl alcohol between the contacts and pads.
Maintenance
- 040-0541-00: Cam switch repair kit (1970)
- TekScope Vol. 9 No. 1, 1977 p.14: Cam switch cleaning tips
Pictures
-
Cam switch in 7A19
-
Cam switch in 7A19
-
Cam switch in 7A19, contact fingers (isolated from spring lever)
-
Cam switch with contacts on both sides of the PCB (7D15)
-
7D15 double-sided switch
-
7D15 double-sided switch
-
7D15 double-sided switch, bottom-side contacts
-
7D15 double-sided switch, through-board pins
-
