Difference between revisions of "N"

From TekWiki
Jump to: navigation, search
(schematics)
(photos)
Line 7: Line 7:
 
from the scope's sweep circuitry.  The input connector is a 50-ohm GR-874.
 
from the scope's sweep circuitry.  The input connector is a 50-ohm GR-874.
 
The Type N was followed by the [[661]] a year later.
 
The Type N was followed by the [[661]] a year later.
 +
  
 
The manual (without schematics) is here:
 
The manual (without schematics) is here:
Line 15: Line 16:
  
 
* http://w140.com/tektronix_type_n_schematics.pdf
 
* http://w140.com/tektronix_type_n_schematics.pdf
 +
 +
<gallery>
 +
Image:Type n front.jpg
 +
Image:Type n right.jpg
 +
Image:Type n left.jpg
 +
Image:Type n top.jpg
 +
Image:Type n bottom2.jpg
 +
Image:Type n bottom.jpg
 +
Image:Type n rear.jpg
 +
</gallery>

Revision as of 13:02, 8 May 2010

The Tektronix Type N is a sampling plug-in introduced in 1960 for 500-series oscilloscopes. It is the first sampler sold by Tektronix. The risetime is specified to be under 600 picoseconds. The Type N is a complete sampling subsystem, using the 500-series oscilloscope just as a power supply and a display. The oscilloscope is operated in X-Y mode and gets its horizontal signal from the Type N plug-in instead of from the scope's sweep circuitry. The input connector is a 50-ohm GR-874. The Type N was followed by the 661 a year later.


The manual (without schematics) is here:

The schematics are here: