Difference between revisions of "N"

From TekWiki
Jump to: navigation, search
Line 22: Line 22:
 
* [http://w140.com/tektronix_type_n_schematics.pdf Tektronix Type N Schematics (PDF)]
 
* [http://w140.com/tektronix_type_n_schematics.pdf Tektronix Type N Schematics (PDF)]
 
* [http://w140.com/tek_fcp/tek_type_n_factory_cal_proc.pdf Tektronix Type N Factory Calibration Procedure (PDF)]
 
* [http://w140.com/tek_fcp/tek_type_n_factory_cal_proc.pdf Tektronix Type N Factory Calibration Procedure (PDF)]
 +
* [http://w140.com/tek_type_n.pdf Tektronix Type N Manual Complete (PDF)]
  
 
<gallery>
 
<gallery>

Revision as of 22:18, 19 April 2011

The Tektronix Type N is a sampling plug-in introduced in 1960 for 500-series scopes. It was the first sampler produced by Tektronix. The risetime is specified to be under 600 picoseconds. The Type N is a complete sampling subsystem, using the 500-series oscilloscope just as a power supply and a display. The oscilloscope is operated in X-Y mode and gets its horizontal signal from the Type N plug-in instead of from the scope's sweep circuitry. The input connector is a 50-ohm GR-874. The Type N was introduced in 1960, followed by the 661 a year later, and discontinued in 1964, making it the shortest-lived plug-in.

The sampling circuit of the Type N is primitive. It uses a single diode, the "interrogate diode", D5480. The strobe pulse is added to the input signal using a passive summing circuit. Consequently, the amplitude of the kick-out pulse from the input is high, about 150mV.

The vertical scale of the Type N is 10mV/cm. The Type N is one of the only Tektronix plug-ins with fixed vertical gain.

For calibration of the timebase of the Type N, the 013-028 Timing Standard was produced.