Difference between revisions of "N"

From TekWiki
Jump to: navigation, search
Line 14: Line 14:
* [[Media:070-209.pdf|Tektronix Type N Manual Complete (PDF, OCR)]]
* [[Media:070-209.pdf|Tektronix Type N Manual Complete (PDF, OCR)]]
* [[Media:tek_type_n_manual_no_schematics.pdf|Tektronix Type N Manual without schematics (PDF, OCR, bad-OCR)]]
* [[Media:tek_type_n_manual_no_schematics.pdf|Tektronix Type N Manual without schematics (PDF, OCR, bad-OCR)]]
* [[Media:tek_type_n_schem.pdf|Tektronix Type N Schematics (PDF, OCR)]]
<!-- * [[Media:tek_type_n_schem.pdf|Tektronix Type N Schematics (PDF, OCR)]] -->
* [[Media:tek_type_n_fcp.pdf|Tektronix Type N Factory Calibration Procedure (PDF, OCR)]]
* [[Media:tek_type_n_fcp.pdf|Tektronix Type N Factory Calibration Procedure (PDF, OCR)]]

Revision as of 16:50, 14 October 2018

Manuals – Specifications – Links – Pictures

The Tektronix Type N is a sampling plug-in for 500-series scopes. It was the first sampler produced by Tektronix. Its risetime is specified to be under 600 picoseconds.

Type N was introduced in 1960, superseded by the Type 661 Sampling Oscilloscope system a year later, and discontinued in 1964.

Type N is a complete sampling subsystem, using the 500-series oscilloscope just as a power supply and a display. The oscilloscope is operated in X-Y mode and gets its horizontal signal from the Type N plug-in instead of from the scope's sweep circuitry. The input signal is applied through a 50 Ω GR-874 connector.

The sampling circuit of the Type N is primitive. It uses a single diode, the "interrogate diode", D5480. The strobe pulse is added to the input signal using a passive summing circuit. Consequently, the amplitude of the kick-out pulse from the input is high, about 150 mV.

The vertical scale of the Type N is fixed at 10 mV/cm, making Type N one of the few Tektronix plug-ins with fixed vertical gain. In practice, attenuators such as the 017-011 can be placed in the signal path, external to the Type N, to achieve the desired sensitivity. Using an input attenuator also has the effect of attenuating the kick-out pulse seen by the device under test.

According to Stefan Graef (http://www.messmuseum.de/tek661.htm),

The engineer behind the N was Norm Winningstad. He worked at Hughes Aircraft Electronics Division and was offered a job at HP's oscilloscope division to join their Sampling Scope team. After getting informed about the work he went to Tektronix developing the N (according to: "A narrative history of Hewlett-Packard from 1939-1990" by John Minck)

For calibration of the timebase of the Type N, the 013-028 Timing Standard was produced.


  • Rise time: 600 ps (Bandwidth ~580 MHz)
  • Deflection: 10 mV/Div (fixed)