Difference between revisions of "Z"

From TekWiki
Jump to: navigation, search
(ten-turn pot, disconnect buttons)
m (correct intro year)
Line 15: Line 15:
 
position on the input switches.
 
position on the input switches.
  
The Type [[P6023]] probe, with R and C compensation, was specifically designed for Type Z.
+
Type Z was introduced in 1960 and uses both tubes and transistors,
 +
capitalizing on each's strengths.
  
Type Z was introduced between 1960 and 1962 and uses both tubes and transistors,
+
The Type [[P6023]] probe, introduced in 1962 with R and C compensation,
capitalizing on each's strengths.
+
was specifically designed for Type Z but also marketed for Type [[G]].
  
 
* http://bama.edebris.com/manuals/tek/z/
 
* http://bama.edebris.com/manuals/tek/z/
 
* http://w140.com/tek_fcp/tek_type_z_factory_cal_proc.pdf
 
* http://w140.com/tek_fcp/tek_type_z_factory_cal_proc.pdf

Revision as of 17:32, 21 September 2010

The Tektronix Type Z is a comparator plug-in for 500-series scopes. Its maximum sensitivity is 50mV/div, and it achieves 40,000 to 1 common-mode rejection at DC and low frequencies. Its risetime as a general-purpose amplifier is 27ns (13MHz bandwidth), but it can track a common-mode risetime of 7ns.

Type Z has two inputs, A and B, plus a precision comparison voltage, Vc, that is adjustable from 0 to +/-1V, 10V, or 100V via a ten-turn pot. It's possible to view A, -B, A-B, A-Vc, or Vc-B.

Unlike later comparators, it has a separate step attenuator for each input, permitting you to view the difference between signals of widely differing amplitudes. It is also the only comparator that can handle +/- 100V common mode at full sensitivity.

With a pair of "Disconnect Signal" buttons, Type Z was the first movement toward a "Gnd" position on the input switches.

Type Z was introduced in 1960 and uses both tubes and transistors, capitalizing on each's strengths.

The Type P6023 probe, introduced in 1962 with R and C compensation, was specifically designed for Type Z but also marketed for Type G.