11301: Difference between revisions
No edit summary |
No edit summary |
||
| Line 51: | Line 51: | ||
The right plug-in can used as the horizontal axis and/or the trigger signal. | The right plug-in can used as the horizontal axis and/or the trigger signal. | ||
The RS-232 interface of the 11301 is implemented using an 8251A UART chip, | |||
interfaced using an MC1488 line drive and an MC1489 line receiver. | |||
==Pictures== | ==Pictures== | ||
Revision as of 13:46, 1 April 2018
The Tektronix 11301 is a programmable 400 MHz analog oscilloscope that takes up to three
11000-series plug-ins or (vertical) 7000-series plug-ins.
Note, however, that the 7000 series plugins have mechanical interlock preventing them from being installed into an 11K mainframe.
The sister model 11302 is basically identical but has a micro-channel plate CRT and 500 MHz bandwidth.
The 11301 has an infrared beam touch screen. There are 10 columns and 14 rows of beams.
The 11301 contains a 77 nanosecond delay line.
Key Specifications
| Bandwidth | 400 MHz |
|---|---|
| Sweep | 5 ns/Div to 500 ms/Div, 1-2-5, ×10 magnifier (same specs for delayed time base) |
| Triggering | 0.35 Div (int) or 20 mV (ext) to 50 MHz, increasing to 1 Div/150 mV at max. bandwidth |
| Trigger modes | DC, AC (>50 Hz), HF Reject (< 30 kHz), LF reject (>80 kHz), TV (line or field) |
| X-Y operation | X from center plugin, bandwidth 3 MHz X-Y phase difference <1° to 1 MHz, <3° to 2 MHz |
Internals
The 11301 is an analog oscilloscope that is digitally controlled. Like a typical analog scope, the 11301 has vertical amplifiers, a trigger circuit, a timebase/sweep, a horizontal amplifier, and a CRT. Unlike traditional analog scopes, the 11301 contains a significant amount of digital circuitry, including multiple microprocessors. The digital circuitry provides several externally-observable features:
- self-test and diagnosis
- self-calibration
- remote control via RS-232 or GPIB
- on-screen menu-based touch screen user interface
Digital circuitry also implements some features that were traditionally implemented with analog circuitry, e.g., the trigger holdoff is implemented with a counter instead of with a multivibrator.
There are many DAC-generated analog control voltages in the 11301.
The left and center plug-in can be used as the vertical axis and/or the trigger signal. The right plug-in can used as the horizontal axis and/or the trigger signal.
The RS-232 interface of the 11301 is implemented using an 8251A UART chip, interfaced using an MC1488 line drive and an MC1489 line receiver.
