5110: Difference between revisions

Revision as of 22:45, 22 May 2018

{{{manufacturer}}}
2 MHz mainframe Tektronix 5110 Produced from 1976 to 1991 Manuals Tektronix 5110 Manual (PDF) (All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The Tektronix 5110 is a 5000-series three-bay mainframe.

Earlier incarnations of it were known as 5103N and D10. It has a large 8×10 division CRT screen where each division is 0.5 in (12.6 mm) instead of the standard 1 cm per division.

Specifications

It is specified to have a 2 MHz bandwidth with a 5A18N vertical plug-in.

The phase difference between X and Y channels is specified to be less than 1 degree at 100 kHz.

P31 phosphor was standard. P7 and P11 were optional. CRT acceleration voltage is 3,500 V. There is no post-deflection acceleration.

Prices

1990: $2,420

Internals

This oscilloscope contains three main boards. Interface Board, Power Supply (LV) and High Voltage/Deflection Board. The Interface board is behind the plug-in Bays and contains basic trace/circuit to collect the signals from the Plug-ins. Single Beam Aux Board - used to combine vertical signals from both Vertical plug-ins - is mounted behind the Interface board in a slot. Optional "Signals out board" is also mounted behind the interface board - used to buffer output signals to the Co-Ax connectors behind the chassis. HV Deflection board contains the Vertical and Horizontal stages driving CRT, Unblanking and CRT HV Circuit. LV Power supply board mounted at the bottom provides regulated +30, -30, +5 and unregulated +38, -38, +200. CRT heater is powered from main transformer.

Pictures

5110 Front Panel
5110 Front Panel
Tek 5110 Rear Panel
5110 Under Chassis
5110 LH W/O Cover
5110 Top W/O Cover
Tek 5110 A3 Interface Board
Ten 5110 A4 Board
Tek 5110 A1 - HV Deflection Board
Tek 5110 A5 - Signals Output Board
Tek 5110 - A2 - Single Beam Auxiliary Board

@@ Line 22: / Line 22: @@
 ==Prices==
 : $2,420
+==Internals==
+This oscilloscope contains three main boards. Interface Board, Power Supply (LV) and High Voltage/Deflection Board.
+The Interface board is behind the plug-in Bays and contains basic trace/circuit to collect the signals from the Plug-ins.
+Single Beam Aux Board - used to combine vertical signals from both Vertical plug-ins - is mounted behind the Interface board in a slot.
+Optional "Signals out board" is also mounted behind the interface board - used to buffer output signals to the Co-Ax connectors behind the chassis.
+HV Deflection board contains the Vertical and Horizontal stages driving CRT, Unblanking and CRT HV Circuit.
+LV Power supply board mounted at the bottom provides regulated +30, -30, +5 and unregulated +38, -38, +200.
+CRT heater is powered from main transformer.
 ==Pictures==
 <gallery>