2230: Difference between revisions
No edit summary |
No edit summary |
||
| Line 22: | Line 22: | ||
sister model of [[2220]] and [[2221]]. | sister model of [[2220]] and [[2221]]. | ||
It features alphanumeric CRT readout of many of the front panel controls. | It features alphanumeric CRT readout of many of the front panel controls. It has both an analog mode and a digital mode. | ||
In the digital storage mode, up to three waveform sets (CH 1 and/or CH 2) | In the digital storage mode, up to three waveform sets (CH 1 and/or CH 2) | ||
may be stored in a save ref. memory and recalled for display at a later time. | may be stored in a save ref. memory and recalled for display at a later time. | ||
It has a DB-9 connector on the right side. A XY plotter can be attached to this port to make permanent copies of the display. This feature can be accessed through the "Mem select" menu. | |||
Some Firmware versions have a diagnostics menu with the Tektronix logo and wizard image. | |||
The Cursor knob is prone to failure. It becomes jittery and will not scroll properly. | |||
{{BeginSpecs}} | {{BeginSpecs}} | ||
{{Spec | Bandwidth | 100 MHz (analog) }} | {{Spec | Bandwidth | 100 MHz (analog) }} | ||
| Line 43: | Line 48: | ||
==Links== | ==Links== | ||
* [http://www.hakanh.com/dl/docs/troubleshooting_tips_on_2200_ps.pdf Troubleshooting tips on 2200 PSU] | * [http://www.hakanh.com/dl/docs/troubleshooting_tips_on_2200_ps.pdf Troubleshooting tips on 2200 PSU] | ||
* [http://www.valachnet.cz/lvanek/diy/tek2230/index.html Measuring inductance using a 2230] | |||
==Pictures== | ==Pictures== | ||
<gallery> | <gallery> | ||
Revision as of 07:08, 6 March 2019
The Tektronix 2230 is a portable 100 MHz, dual-channel combination analog / digital storage scope, sister model of 2220 and 2221.
It features alphanumeric CRT readout of many of the front panel controls. It has both an analog mode and a digital mode. In the digital storage mode, up to three waveform sets (CH 1 and/or CH 2) may be stored in a save ref. memory and recalled for display at a later time.
It has a DB-9 connector on the right side. A XY plotter can be attached to this port to make permanent copies of the display. This feature can be accessed through the "Mem select" menu.
Some Firmware versions have a diagnostics menu with the Tektronix logo and wizard image.
The Cursor knob is prone to failure. It becomes jittery and will not scroll properly.
Key Specifications
| Bandwidth | 100 MHz (analog) |
|---|---|
| Sampling rate | 20 MS/s |
| Record length | 1K or 4K samples (single channel), optional 26K |
| Features |
|
please add
Links
Pictures
-
-
-
-
-
-
2230A Signal Input Board
-
2230 interface board
-
upper most board
