1A4: Difference between revisions

Line 2:

Like the Type [[1A2]] and unlike the Type [[1A1]], the Type 1A4 has a Trigger Output selector that controls which channel provides triggering when the mainframe trigger is in Plug-In mode.

The signal path of each channel of the 1A4 is as follows. First the signal passes through the attenuators. Then it is clamped by two diodes and applied the the gate of a JFET source follower. The source of the source follower is the trigger pickoff point. From there the vertical signal path goes through an NPN emitter follower followed by an NPN differential amplifier, at which point the signal becomes differential. Next, the signal passes through an analog multiplexer made with [[1N4152]] silicon switching diodes. After the multiplexer network, the signal passes through a common base amplifier followed by [[6DJ8]] tube operating in common grid configuration. Type 1A4 was [[introduced in 1967]] and lasted until the end of the classic ~~plugin~~ scope line in 1974.

The signal path of each channel of the 1A4 is as follows. First the signal passes through the attenuators. Then it is clamped by two diodes and applied the the gate of a JFET source follower. The source of the source follower is the trigger pickoff point. From there the vertical signal path goes through an NPN emitter follower followed by an NPN differential amplifier, at which point the signal becomes differential. Next, the signal passes through an analog multiplexer made with [[1N4152]] silicon switching diodes. After the multiplexer network, the signal passes through a common base amplifier followed by [[6DJ8]] tube operating in common grid configuration. Type 1A4 was [[introduced in 1967]] and lasted until the end of the classic plug-in scope line in 1974.

* [http://bama.edebris.com/manuals/tek/1a4 1A4 manual on BAMA]

@@ Line 2: / Line 2: @@
 Like the Type [[1A2]] and unlike the Type [[1A1]], the Type 1A4 has a Trigger Output selector that controls which channel provides triggering when the mainframe trigger is in Plug-In mode.
-The signal path of each channel of the 1A4 is as follows.  First the signal passes through the attenuators.  Then it is clamped by two diodes and applied the the gate of a JFET source follower.  The source of the source follower is the trigger pickoff point.  From there the vertical signal path goes through an NPN emitter follower followed by an NPN differential amplifier, at which point the signal becomes differential.  Next, the signal passes through an analog multiplexer made with [[1N4152]] silicon switching diodes.  After the multiplexer network, the signal passes through a common base amplifier followed by [[6DJ8]] tube operating in common grid configuration.  Type 1A4 was [[introduced in 1967]] and lasted until the end of the classic plugin scope line in 1974.
+The signal path of each channel of the 1A4 is as follows.  First the signal passes through the attenuators.  Then it is clamped by two diodes and applied the the gate of a JFET source follower.  The source of the source follower is the trigger pickoff point.  From there the vertical signal path goes through an NPN emitter follower followed by an NPN differential amplifier, at which point the signal becomes differential.  Next, the signal passes through an analog multiplexer made with [[1N4152]] silicon switching diodes.  After the multiplexer network, the signal passes through a common base amplifier followed by [[6DJ8]] tube operating in common grid configuration.  Type 1A4 was [[introduced in 1967]] and lasted until the end of the classic plug-in scope line in 1974.
 * [http://bama.edebris.com/manuals/tek/1a4 1A4 manual on BAMA]

1A4: Difference between revisions

Navigation menu