1S2: Difference between revisions
(elaborated on how it is used) |
No edit summary |
||
Line 1: | Line 1: | ||
The 1S2 is a sampling/TDR plug-in 500-series scopes. Like the 1S1, it is a complete sampling subsystem and uses the mainframe as a power supply and low-speed display. Unlike the 1S1, it contains pulsers that allows it to perform time-domain reflectography (TDR) measurements. The 1S2 has two 50-ohm pulsers, one of which is active at a time. One puts out a 250mV pulse with 50ps risetime. The other puts out a slower 1 volt pulse. The sampling bridge is a feed-through type. For TDR measurements, the signal from one of the internal pulsers is send through the sampler, and out to the the transmission line being tested. Returning pulses are detected | The 1S2 is a sampling/TDR plug-in 500-series scopes. Like the 1S1, it is a complete sampling subsystem and uses the mainframe as a power supply and low-speed display. Unlike the 1S1, it contains pulsers that allows it to perform time-domain reflectography (TDR) measurements. The 1S2 has two 50-ohm pulsers, one of which is active at a time. One puts out a 250mV pulse with 50ps risetime. The other puts out a slower 1 volt pulse. The sampling bridge is a feed-through type. For TDR measurements, the signal from one of the internal pulsers is send through the sampler, and out to the the transmission line being tested. Returning pulses are detected | ||
as they pass back through the sampler, and they are reabsorbed by the 50-ohm impedance of the pulser. | as they pass back through the sampler, and they are reabsorbed by the 50-ohm impedance of the pulser. Like all plug-ins, the 1S2 uses the mainframe for power. Output can be either to the CRT of the mainframe or to a plotter or low-speed data acquisition device via banana connectors on the front of the 1S2. | ||
==References== | ==References== |
Revision as of 15:04, 19 December 2008
The 1S2 is a sampling/TDR plug-in 500-series scopes. Like the 1S1, it is a complete sampling subsystem and uses the mainframe as a power supply and low-speed display. Unlike the 1S1, it contains pulsers that allows it to perform time-domain reflectography (TDR) measurements. The 1S2 has two 50-ohm pulsers, one of which is active at a time. One puts out a 250mV pulse with 50ps risetime. The other puts out a slower 1 volt pulse. The sampling bridge is a feed-through type. For TDR measurements, the signal from one of the internal pulsers is send through the sampler, and out to the the transmission line being tested. Returning pulses are detected as they pass back through the sampler, and they are reabsorbed by the 50-ohm impedance of the pulser. Like all plug-ins, the 1S2 uses the mainframe for power. Output can be either to the CRT of the mainframe or to a plotter or low-speed data acquisition device via banana connectors on the front of the 1S2.