106: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 10: | Line 10: | ||
clip a high amplitude signal. In units with serial numbers less than 1190, GaAs diodes were used | clip a high amplitude signal. In units with serial numbers less than 1190, GaAs diodes were used | ||
for clipping. After serial number 1190, silicon diodes were used. | for clipping. After serial number 1190, silicon diodes were used. | ||
The high amplitude output stage of the 106 is make of four [[7189]] tubes in parallel. | |||
* [http://w140.com/tek_106.pdf Tektronix 106 Manual (PDF)] | * [http://w140.com/tek_106.pdf Tektronix 106 Manual (PDF)] | ||
Revision as of 12:39, 24 April 2011
The Tektronix Type 106 is a squarewave generator introduced in 1966. It has four outputs:
- Fast Rise +Output: 500mV into 50 ohm load, positive-going pulse, 1ns risetime, 50-ohm output impedance, GR connector
- Fast Rise -Output: 500mV into 50 ohm load, negative-going pulse, 1ns risetime, 50-ohm output impedance, GR connector
- High Amplitude Output: 12V into 50 ohm load, 12ns-risetime, 600-ohm output impedance, GR connector
- Trigger Output: 100mV into 50 ohm load, 50ns risetime, 150 ohm output impedance, BNC connector
The 1ns-risetime outputs are generated using diodes to clip a high amplitude signal. In units with serial numbers less than 1190, GaAs diodes were used for clipping. After serial number 1190, silicon diodes were used.
The high amplitude output stage of the 106 is make of four 7189 tubes in parallel.
-
Front
-
Rear
-
Schematic
-
Silicon Diode Conversion
