106: Difference between revisions
Jump to navigation
Jump to search
Vintage dave (talk | contribs) m (7189A not 7189 - pinouts not quite compatible) |
No edit summary |
||
| Line 21: | Line 21: | ||
Image:106 sch.png|Schematic | Image:106 sch.png|Schematic | ||
Image:106 sidiode.png|Silicon Diode Conversion | Image:106 sidiode.png|Silicon Diode Conversion | ||
Image:Tek 106 on 2235.jpg|106 pulse on [[2235]] | |||
Image:Tek 106 rise.jpg|106 pulse on [[567]] with [[S4]] | |||
</gallery> | </gallery> | ||
Revision as of 11:22, 21 August 2011
The Tektronix Type 106 is a squarewave generator introduced in 1966. It has four outputs:
- Fast Rise +Output: 500mV into 50 ohm load, positive-going pulse, 1ns risetime, 50-ohm output impedance, GR connector
- Fast Rise -Output: 500mV into 50 ohm load, negative-going pulse, 1ns risetime, 50-ohm output impedance, GR connector
- High Amplitude Output: 12V into 50 ohm load, 12ns-risetime, 600-ohm output impedance, GR connector
- Trigger Output: 100mV into 50 ohm load, 50ns risetime, 150 ohm output impedance, BNC connector
The 1ns-risetime outputs are generated using diodes to clip a high amplitude signal. In units with serial numbers less than 1190, GaAs diodes were used for clipping. After serial number 1190, silicon diodes were used.
The high amplitude output stage of the 106 is made of four 7189A tubes in parallel. With moderate effort, the socket wiring can be made compatible with the 7189 aka 6BQ5.
-
Front
-
Rear
-
Schematic
-
Silicon Diode Conversion
-
106 pulse on 2235
-
