5110: Difference between revisions

Revision as of 13:06, 12 April 2019

{{{manufacturer}}}
2 MHz mainframe Tektronix 5110 Produced from 1976 to 1991 Manuals Tektronix 5110 Manual (PDF) (All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The Tektronix 5110 is a 5000-series three-bay mainframe.

Earlier incarnations of it were known as 5103N and D10. It has a large 8×10 division CRT screen where each division is 0.5 in (12.7 mm) instead of the standard 1 cm per division.

Specifications

It is specified to have a 2 MHz bandwidth with a 5A18N vertical plug-in.

The phase difference between X and Y channels is specified to be less than 1 degree at 100 kHz.

P31 phosphor was standard. P7 and P11 were optional. CRT acceleration voltage is 3,500 V. There is no post-deflection acceleration.

Prices

1990: $2,420

Internals

This oscilloscope contains three main boards. Interface Board, Power Supply (LV) and High Voltage/Deflection Board. The Interface board is behind the plug-in Bays and contains basic trace/circuit to collect the signals from the Plug-ins. Single Beam Aux Board - used to combine vertical signals from both Vertical plug-ins - is mounted behind the Interface board in a slot. Optional "Signals out board" is also mounted behind the interface board - used to buffer output signals to the Co-Ax connectors behind the chassis. HV Deflection board contains the Vertical and Horizontal stages driving CRT, Unblanking and CRT HV Circuit. LV Power supply board mounted at the bottom provides regulated +30, -30, +5 and unregulated +38, -38, +200. CRT heater is powered from main transformer.

Links

Rajesh's Tek 5110 and 5A19N Repair (PDF)

Pictures

5110 Front Panel
5110 Front Panel
Tek 5110 Rear Panel
5110 Under Chassis
5110 LH W/O Cover
5110 Top W/O Cover
Tek 5110 A3 Interface Board
Ten 5110 A4 Board
Tek 5110 A1 - HV Deflection Board
Tek 5110 A5 - Signals Output Board
Tek 5110 - A2 - Single Beam Auxiliary Board

@@ Line 11: / Line 11: @@
 The '''Tektronix 5110''' is a 5000-series three-bay mainframe.
-Earlier incarnations of it were known as [[5103|5103N]] and [[D10]].  It has a large 8&times;10 division CRT screen where each division is 0.5 in (12.6 mm) instead of the standard 1 cm per division.
+Earlier incarnations of it were known as [[5103|5103N]] and [[D10]].  It has a large 8&times;10 division CRT screen where each division is 0.5 in (12.7 mm) instead of the standard 1 cm per division.
 ==Specifications==