Z: Difference between revisions
No edit summary |
No edit summary |
||
Line 8: | Line 8: | ||
series=[[500-series scopes]]| | series=[[500-series scopes]]| | ||
manuals= | manuals= | ||
* [ | * [[Media:070-251.pdf|Tektronix Type Z Manual (PDF, needs OCR)]] | ||
* [http://bama.edebris.com/manuals/tek/z/ Tektronix Type Z Manual (BAMA | * [http://bama.edebris.com/manuals/tek/z/ Tektronix Type Z Manual (BAMA)] | ||
* [http://w140.com/tek_fcp/tek_type_z_factory_cal_proc.pdf Tektronix Type Z Factory Calibration Procedure (PDF)] | * [http://w140.com/tek_fcp/tek_type_z_factory_cal_proc.pdf Tektronix Type Z Factory Calibration Procedure (PDF)] | ||
<!--* [[Media:070-251.pdf|Tektronix Type Z Manual (PDF, OCR, bad-OCR)]]--> | <!--* [[Media:070-251.pdf|Tektronix Type Z Manual (PDF, OCR, bad-OCR)]]--> | ||
Line 70: | Line 70: | ||
Tek_z_schem.png|Main Amplifier | Tek_z_schem.png|Main Amplifier | ||
</gallery> | </gallery> | ||
[[Category:500 series plugins]] | [[Category:500 series plugins]] | ||
[[Category:Differential amplifiers]] | [[Category:Differential amplifiers]] |
Revision as of 06:32, 30 January 2021
Template:Plugin Sidebar 2 The Tektronix Type Z is a comparator plug-in for 500-series scopes. Its two main subsystems are a differential amplifier and a precision variable DC voltage source, which can be used as one of the amplifier inputs. This allows DC-coupled measurements of small signals with large DC offsets. Its maximum sensitivity is 50 mV/div, and it achieves 40,000 to 1 common-mode rejection at DC and low frequencies. Its risetime as a general-purpose amplifier is 27 ns (13 MHz bandwidth), but it can track a common-mode risetime of 7 ns.
The Type Z has two inputs, A and B, plus a precision comparison voltage, VC, that is adjustable from 0 to ±1 V, 10 V, or 100 V via a ten-turn pot. It's possible to view VA, −VB, VA−VB, VA−VC, or VC−VB.
Unlike later comparators, it has a separate step attenuator for each input, permitting the user to view the difference between signals of widely differing amplitudes. It is also the only comparator that can handle ±100 V common mode at full sensitivity. The Type Z uses two turret attenuators.
With a pair of "Disconnect Signal" buttons, the Type Z was the first of the movement toward a "GND" position on the input switches.
The Type Z was introduced in 1960 and uses both tubes and transistors, capitalizing on the strengths of each. It was dropped after 1968.
The Type P6023 probe with R and C compensation, introduced in 1962, was specifically designed for the Type Z but also marketed for the Type G.
Specifications
please add
Links
Pictures
-
Front View
-
Front View
-
Front View
-
Pre-production Type Z with different knob color
-
Left Side
-
Left Side
-
Right Side
-
Right Side
-
Right Side
-
Right Side Tubes
-
Top
-
Rear
Schematic
-
Attenuators
-
Main Amplifier