131

The Tektronix Type 131 is a current probe amplifier used only with the P6016 current probe. Type 131s were never given serial numbers, instead, they were produced chronologically in "Models." Models 1 thru 3 looked alike, while Model 4 got a redesigned enclosure like that used later by the Type 134.

Manuals – Specifications – Links – Pictures

Key Specifications

Sensitivity	1 mA/Div to 1 A/Div, 1−2−5 (scope input fixed at 50 mV/Div)
Noise	0.1 mAp-p
Risetime	20 ns (eq. 17 MHz −3 dB bandwidth)
Lower frequency limit	50 Hz
Delay time	32 ns typ.

(all specifications are overall values including the P6016 probe)

Connectors

All models of the 131 use a BNC input connector.

The vast majority of 131s, including all the Models 1 thru 3, have a UHF output connector. 131 Model 4s with UHF outputs were Tektronix #015-0029-00.

A few very late 131 Model 4s were supplied with a locking BNC output connector, as Tektronix #015-0050-00.

Internals

All four Type 131 models used PNP transistors, thus requiring a negative power source. Models 1 thru 3 were hard-wired to their separate minus ~19 V power supplies, while Model 4 got a power supply, 015-027 for 115 V_AC, with a proprietary Tektronix coaxial connector. While the Type 134 uses the same coaxial power supply connector, the power supplies are not interchangeable. So the Type 131 Model 4 will only work with the correct 015-027 power supply.

See the Type 131 power supply page for more information.

Pictures

• 

  Type 131 Model 3 Front

• 

  Type 131 Model 3 with P6016

• 

  Type 131 Model 3, with attached power supply

• 

  Type 131 Model 3, with UHF to BNC adaptor

• 

  Type 131 Model 3

• 

  Type 131 Model 3

• 

  Type 131 Model 3

• 

  Type 131 Model 3

• 

  Type 131 Model 3

• 

  Type 131 Schematic, Models 1-3

• 

  Type 131 Model 4 Front

• 

  Type 131 Model 4 Side View