067-0532-01
The Tektronix Type 067-0532-01 Calibration Fixture is a Constant Amplitude Signal Generator whose output is a low-distortion sinewave. It is intended to provide a signal of known frequency and amplitude for measuring oscilloscope bandwidth. A 3Mhz sinewave is available as a reference amplitude from which a -3dB measurement can be made. The output connector, amplitude detector, and 50 ohm source resistor are at the end of a 42 inch cable. The amplitude is regulated at the end of the cable adjacent to the output connector. Cable loss and standing-wave errors are essentially eliminated.
Key Specifications
| Frequency | |
|---|---|
| Range | 65Mhz to 500Mhz |
| Accuracy | Within 2% of indicated frequency |
| 3Mhz Frequency Accuracy | Within 5%) |
| Amplitude | |
| Range | 0.5V P-P to 4V P-P into 50Ω in .5V increments |
| Variable | Continuously Variable between calibrated steps. Max Output 4.2V |
| 3Mhz Amplitude Accuracy | Within 2% of indicated amplitude |
| Constant Amplitude Accuracy | |
| 65Mhz to 300Mhz | Within 2% of indicated amplitude |
| 300Mhz to 500Mhz | Within 5% of indicated amplitude |
| Output Source Impedance | 50Ω within 1% |
Manuals
Pictures
-
Front View
-
Left Side
-
Top Internal
-
Bottom Internal
-
Left Internal
-
Right Internal
-
Signal Generator Circuit
-
Line Filter Board
