067-0500-00: Difference between revisions

From TekWiki
Jump to navigation Jump to search
(cat)
No edit summary
Line 1: Line 1:
The Tektronix 067-0500-00 (also known as [[3M1]]) is a calibration fixture for adjusting the normalizing capacitor  
The '''Tektronix 067-0500-00''' (also known as [[3M1]]) is a calibration fixture for adjusting the normalizing capacitor  
behind the plug-in connector in [[560-series scopes]].
behind the plug-in connector in [[560-series scopes]].
It consists of a Schmitt trigger that is driven from  
It consists of a Schmitt trigger that is driven from  
a single-ended input coming from a BNC connector on the front panel.   
a single-ended input coming from a BNC connector on the front panel.   
Line 11: Line 12:
to produce clean transient response in the normalized scope.
to produce clean transient response in the normalized scope.


The manual is here: [[http://bama.edebris.com/download/tek/067-0500-00/Tek%20067-0500-00.pdf]]
==Manuals==
* [http://bama.edebris.com/download/tek/067-0500-00/Tek%20067-0500-00.pdf 067-0500-00 Manual @ BAMA]


==Pictures==
<gallery>
<gallery>
Image:067-0500-00_front.jpg
067-0500-00_front.jpg
Image:067-0500-00_schem.jpg
067-0500-00_schem.jpg
Image:067-0500-00_insides.jpg
067-0500-00_insides.jpg
</gallery>
</gallery>


[[Category:Calibration fixtures]]
[[Category:Calibration fixtures]]
[[Category:560 series plugins]]
[[Category:560 series plugins]]

Revision as of 11:18, 5 February 2016

The Tektronix 067-0500-00 (also known as 3M1) is a calibration fixture for adjusting the normalizing capacitor behind the plug-in connector in 560-series scopes.

It consists of a Schmitt trigger that is driven from a single-ended input coming from a BNC connector on the front panel. The Schmitt trigger produces balanced output signals with controlled source impedance. The normalizing capacitor is adjusted using a procedure similar to adjusting probe compensation. When adjusted correctly, the voltage division ratio formed by the plug-in's output impedance and the mainframe's input impedance should be a real value which does not change across the specified frequency range of the scope. After the scope is normalized using the 067-0500-00, other plug-ins can be adjusted to produce clean transient response in the normalized scope.

Manuals

Pictures