500-series plug-in connector

500-series scopes (53x, 54x, and 55x) and 127, 132, 133 have bays that take letter-series and 1-series plug-ins which typically control the vertical axis of the display. Two exceptions are the 555 and the 536. The 555 additionally takes two 555-specific timing/sweep plug-ins (21, 22, 21A, 22A) that control the horizontal deflection of the two beams. The 536 takes two letter-series or 1-series plug-ins; One controls vertical, the other horizontal, in XY mode.

The pinout changed significantly in the 20+ year run of the 500 series. Pins 1, 2, 3, 8, 16, and all power supply pins remained the same, however. The Type T timebase plugin and it's host, the horizontal bay in the 536 also have a banana jack mounted above the main connector for retrace blanking.

580-series scopes use their own very similar plug-ins.

The pinout on the connector is as follows:

Pin number	Function
1	Signal +
2	GND
3	Signal -
4	Trigger - 544, 546, 547, 549, late 555s, and 556
5	Trigger + 544, 546, 547, 549, late 555s, and 556
6	Sawtooth (556 only?)
7	Alt Timebase sync on 547
8	Multi-Trace Sync
9	-150 V DC
10	+100V DC
11	+225V DC
12	+350V DC
13	6.3V AC relative to pin 14
14	6.3V AC relative to pin 13
15	+75V DC
16	Multi-Trace Sync

• 

  Pinout shown in 556 schematic

• 

  Pinout shown in 1A2 schematic

• 

  Male pins on plugin

• 

  Rear lugs on plugin