1,537
edits
L: Difference between revisions
Jump to navigation
Jump to search
m
Circuit Summary
No edit summary |
m (Circuit Summary) |
||
| (4 intermediate revisions by 3 users not shown) | |||
| Line 11: | Line 11: | ||
* [http://w140.com/tek_fcp/tek_type_l_factory_cal_proc.pdf Tektronix Type L Factory Calibration Procedure (PDF)] | * [http://w140.com/tek_fcp/tek_type_l_factory_cal_proc.pdf Tektronix Type L Factory Calibration Procedure (PDF)] | ||
* [[Media:tek_type_l_fcp.pdf|Tektronix Type L Factory Calibration Procedure (PDF, OCR)]] | * [[Media:070-336.pdf|Tektronix Type L Manual (PDF, OCR, bad-OCR)]] | ||
* [[Media:tek_type_l_fcp.pdf|Tektronix Type L Factory Calibration Procedure (PDF, OCR, bad-OCR)]] | |||
}} | }} | ||
The '''Tektronix Type L''' is an amplifier plug-in for [[500-series scopes]]. | The '''Tektronix Type L''' is an amplifier plug-in for [[500-series scopes]]. | ||
| Line 32: | Line 33: | ||
{{MissingSpecs}} | {{MissingSpecs}} | ||
==Internals== | |||
The input is switched via a Frequency compensated attenuator network which is controlled by the Vols/CM Switch. | |||
Input is then coupled to first cathode follower V5832, a 5654/6AK5W RF Pentode. This is configured as a cathode follower. | |||
The screen supply of this cathode follower is switched from +100 to a decoupled network from +225V rail when the X10 Mode is selected. | |||
The output of input amplifier is then switched via a 10X Amplifier - if the X10 mode is selected in the front panel - or directly to the paraphase or phase inverter made up of two [[12AU6]] tubes. This stage converts the input signal to a differential push-pull output. This output is passed to the final output drivers, which are two cathode follower sections with a pair of [[12AT7]] tubes. The differential output is then passed to pin 1 and 3 of the connector to drive the vertical amplifier inside the chassis. | |||
The 10X amplifier stage is built with 3 5654/6AK5W tubes. First two are configured as amplifier and the last one as output cathode follower. | |||
Heater for the tubes are derived from +75VDC heater supply available at pin 15 of the connector. This is to avoid any interference/hum from the regular AC heater supply at 60Hz. | |||
==Pictures== | ==Pictures== | ||
| Line 41: | Line 54: | ||
Tek type l left.jpg | Tek type l left.jpg | ||
Tek type l bottom.jpg | Tek type l bottom.jpg | ||
Tek type l in 541a.jpg|Type L in [[541|541A]] | Tek type l in 541a.jpg|Type L in [[541|541A]] | ||
Tek type l perf.png | Performance in Different Scopes | Tek type l perf.png | Performance in Different Scopes | ||