O: Difference between revisions

From TekWiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 12: Line 12:


The Type O can be used with any of the following adapters:  
The Type O can be used with any of the following adapters:  
[[013-081]], [[013-068]], [[013-0048-01]], [[013-0049-01]], [[013-0086-00]], [[013-0067-00]].
[[013-081]], [[013-068]], [[013-0048-01]], [[013-0049-01]], [[013-0086-00]], [[013-0067-00]] (manual below).


* [http://bama.edebris.com/manuals/tek/o/ Tektronix Type O Manual (BAMA)]
* [http://bama.edebris.com/manuals/tek/o/ Tektronix Type O Manual (BAMA)]
* [http://w140.com/tek_fcp/tek_type_o_factory_cal_proc.pdf Tektronix Type O Factory Calibration Procedure (PDF)]
* [http://w140.com/tek_fcp/tek_type_o_factory_cal_proc.pdf Tektronix Type O Factory Calibration Procedure (PDF)]
* [http://w140.com/tek_type-o_1968_catalog.pdf Tektronix Type O in 1968 Catalog (PDF)]
* [http://w140.com/tek_type-o_1968_catalog.pdf Tektronix Type O in 1968 Catalog (PDF)]
* [http://w140.com/013-067_Log_adapter.pdf Tektronix 013-067 Log Adapter Manual (PDF)]


<gallery>
<gallery>

Revision as of 16:13, 19 April 2014

The Type O is a letter-series plug-in that contains two op-amps. The input and feedback networks of the op-amps can be configured from the front panel using knobs and/or user-supplied components. There are sockets on the front panel for banana plugs. Type O also has a regular signal input that does not involve the op-amps. A mode switch selects which op-amp's output will be displayed, or the regular signal input.

Regular signal bandwidth is 25MHz, maximum sensitivity is 50mV/div, op-amp gain-bandwidth product is 15MHz, and open-loop DC gain is 2500.

Type O was introduced in mid-1962 and it was "in at the finish", available right up to the discontinuance of the entire classic plug-in scope line in 1974.

The Type O can be used with any of the following adapters: 013-081, 013-068, 013-0048-01, 013-0049-01, 013-0086-00, 013-0067-00 (manual below).