P6032: Difference between revisions

P6032 (view source)

31 bytes removed , 7 December 2008

no edit summary

31,832

edits

Revision as of 16:17, 7 December 2008 (view source) Kurt (talk \| contribs) No edit summary ← Older edit		Revision as of 16:20, 7 December 2008 (view source) Kurt (talk \| contribs) No edit summary Newer edit →
Line 1:		Line 1:
	The P6032 is a high-speed cathode-follower probe. There is a miniature triode in the probe body. Like all active probes, the P6032 requires power, and for this reason it has two connectors at the scope end of cable. There is a four-pin power connector and a 50-Ohm GR connector for the signal. The triode has limited dynamic range, so attenuator attachments are provided that attach to the tip of the probe. These attenuators also reduce the loading of the probe on the probed circuit. The probe was rated to 850MHz.		The P6032 is a high-speed cathode-follower probe. There is a miniature triode in the probe body. Like all active probes, the P6032 requires power, and for this reason it has two connectors at the scope end of cable. There is a four-pin power connector and a 50-Ohm GR connector for the signal. The triode has limited dynamic range, so attenuator attachments are provided that attach to the tip of the probe. These attenuators also reduce the loading of the probe on the probed circuit. The probe was rated to 850MHz.
	[[Image:~~http://w140.com/kurt/pix/p6032/~~p6032_ext.jpg\|thumb]]		[[Image:p6032_ext.jpg\|thumb]]