P7001

The Tektronix P7001 is a digitizer, processor, and memory for the 7704 oscilloscope. It has a backplane with an asynchronous bus and several cards that plug into that bus: sampler, analog to digital converter, memory, external digital interface, and display electronics. Early versions of the P7001 use core memory. Later versions use semiconductor RAM. The P7001 assumes a repeating input signal and periodically samples the horizontal and vertical signals simultaneously. This allows it to fill the memory with data points represented as coordinate pairs, (x1,y1), (x2,y2), (x3,y3), etc. It is not necessary that x2 be greater than x1. The samples can be taken out-of-order with respect to their equivalent time in the waveform. The signal coming from the acquisition unit enters a fast four-diode sample and hold circuit where it is sampled at 150Ksamp/sec. Each sample is digitized using a successive-approximation scheme. The analog to digital converter is made of several chips: a digital to analog converter, a comparator, and control logic. The P7001 has its own power supply built into it, independent from the power supply in the acquisition unit of the 7704A. The bus is used for low speed signals. High speed signals are sent through coaxial cables that connect to the cards using Peltola connectors.

Manuals are here: http://w140.com/p7001/

<gallery> Image:P7001 front.jpg|Front panel Image:P7001 top.jpg|Top view Image:P7001 bus front.jpg|Front of backplane Image:P7001 bus back.jpg|Rear of backplane Image:P7001 connector3.jpg|Interunit connector Image:P7001 connector2.jpg|Interunit connector Image:P7001 connector1.jpg|Interunit connector Image:P7001 dpo controller.jpg|Controller card Image:P7001 dpo controller board.jpg|Controller card Image:P7001 dpo controller back.jpg|Controller card Image:P7001 diode decoder.jpg|Address decoder Image:P7001 core boards.jpg|Core boards Image:Core mat.jpg|Core memory Image:Core20.jpg|Core closeup Image:Core17.jpg|Core closeup Image:P7001 ps.jpg|Switching power supply <gallery>