Potentiometers/Repairs

From TekWiki
Revision as of 08:31, 30 March 2021 by Jadney (talk | contribs)
Jump to navigation Jump to search

Most of the problems with the Tek-made VAR pots seem to be noise or intermittent connections. These can usually be overcome by simply running the pot back and forth across the bad section and thru its full range. OTOH, several of them that I've come across have suffered from broken plastic that keeps the set screw from holding tightly to the shaft. The plastic at the center of the cruciform section is a bit too thin at the center, so it cracks there, allowing the plastic and set screw to back away from the shaft.

I solved this problem by making some small aluminum rings with #4-40 tapped holes. The rings fit snugly around the cruciform and and hold those parts together. A stainless set screw passes thru the OE threaded part of the plastic and can be tightened against the shaft. The OD of the rings I made is about 3/4". The ID and width are made to fit the pot. For the best fit, the ID could have a slight taper. For my use, I drilled and tapped two different #4-40 holes, at different offsets, so I could pick the one that was the best fit to the pot.

The set screw shown in my repaired 3A8 may look like it could be shorter, but it causes no problem in this application and ensures full thread engagement in the aluminum ring. I think the photos show the idea pretty clearly.