S-52

The Tektronix S-52 is a pulse generator head compatible with S-series sampling units like the 3S2, 7S11, and 7S12.

It puts out a 200 mV pulse into a load of 50 Ω. The pulse has a rise time of 25 ps or less. The output is an SMA connector.

In addition to the main pulse output, the S-52 also produces a pre-trigger pulse 85 ns before the main pulse. The delay is generated with a digital counter, and jitter between the pre-trigger pulse and the main pulse is specified as less than 10 ps. The pre-trigger pulse uses a BSM connector.

The S-52 generates the main output pulse using a 50 mA low-capacitance tunnel diode with part number 153-0400-00.

The S-52 is similar to the S-50, but the S-50 has twice the pulse amplitude. The reason for this is that the S-52 has a 48 Ω resistor between the output tunnel diode and the output connector providing back termination, while the S-50 has no such resistor. Although the S-52 produces a smaller pulse, its output impedance is much better controlled than that of the S-50, and the output resistor may also provide some limited protection for the output tunnel diode.

Key Specifications

Rise time	< 25 ps
Output amplitude	200 mV into 50 Ω (SMA)
Output impedance	50 Ω «reverse terminated» (i.e. having controlled source impedance)
Pre-trigger output	85 ns before main pulse (jitter < 10 ps), +1 V into 50 Ω (BSM)

Links

• Tek S-52 page @ amplifier.cd
• http://www.barrytech.com/tektronix/tek7000/teks52.html

Pictures

• 

  S-52 front

• 

  S-52 pulse generator and S-6 sampling head in a 7S12 TDR/Sampler plugin

Internal

• 

  A1 Timing board (right)

• 

  A3 Trigger board (left)

• 

  A2 Tunnel Diode Control board (center)

• 

  Tunnel diode mount

• 

  Tunnel diode mount, detail

• 

  Schematic

Measurements

• 

  7S12 displaying the incident pulse from an S-52 (nom. < 25 ps) through an S-6 head (nom. < 30 ps).