Z: Difference between revisions

From TekWiki
Jump to navigation Jump to search
m (correct intro year)
mNo edit summary
Line 16: Line 16:


Type Z was introduced in 1960 and uses both tubes and transistors,
Type Z was introduced in 1960 and uses both tubes and transistors,
capitalizing on each's strengths.
capitalizing on each's strengths.  It was dropped after 1968.


The Type [[P6023]] probe, introduced in 1962 with R and C compensation,
The Type [[P6023]] probe, introduced in 1962 with R and C compensation,

Revision as of 17:57, 24 September 2010

The Tektronix Type Z is a comparator plug-in for 500-series scopes. Its maximum sensitivity is 50mV/div, and it achieves 40,000 to 1 common-mode rejection at DC and low frequencies. Its risetime as a general-purpose amplifier is 27ns (13MHz bandwidth), but it can track a common-mode risetime of 7ns.

Type Z has two inputs, A and B, plus a precision comparison voltage, Vc, that is adjustable from 0 to +/-1V, 10V, or 100V via a ten-turn pot. It's possible to view A, -B, A-B, A-Vc, or Vc-B.

Unlike later comparators, it has a separate step attenuator for each input, permitting you to view the difference between signals of widely differing amplitudes. It is also the only comparator that can handle +/- 100V common mode at full sensitivity.

With a pair of "Disconnect Signal" buttons, Type Z was the first movement toward a "Gnd" position on the input switches.

Type Z was introduced in 1960 and uses both tubes and transistors, capitalizing on each's strengths. It was dropped after 1968.

The Type P6023 probe, introduced in 1962 with R and C compensation, was specifically designed for Type Z but also marketed for Type G.