7T11

The 7T11 is a time base plug-in for the 7000 mainframe family. It was specially designed to build a sampling oscilloscope configuration together with the 7S11 including one of the sampling heads. The fastest sweep is 10ps/div and lowest jitter is 10ps, depending on actual settings.

Trigger bandwidth is 500MHz from internal and 1 GHz from external trigger sources. Additionally there is an internal 200MHz oscillator with analog trigger count down, which can be synchronized from external signals up to 14GHz.

Due its sampling principle (so called undersampling) it can only be used on periodic signals and samples are always taken from signal portions delayed from the trigger event. This delay is adjustable on the front panel to select the portion of interest. At the three lowest sweep ranges the 7T11 changes from the undersampling principles to real-time sampling.

Due the high bandwidth of the sampling heads, there is no Y-delay-line in the heads, so the 7T11 needs an external pre-trigger, if there are random, high jitter signals or if the original signal triggered onto shall be observed. In the special case of a periodic signal with low jitter, a random sampling mode can be used, so that the signal triggered on can be observed. In this case an internal PLL locks to the signal and generates an internal pre-trigger. If only bandwidths of up to 3GHz are needed, single events can be observed directly be using the 7M11 analog delay line plug-in.

Manual or external sweep is possible to connect a slow pen plotter.

Because the 7T11 and 7S11 have direct interconnections side by side, they work also in slow mainframes. The 7T11 supports up to two 7S11 and allows also x-y operation.

The 7T11 uses a BSM connector for pulse output on the front panel.

Right view
Left view
noisy 8GHz taken with 7T11,7S11,S6,7904
Tunnel Diode CR28 in a 7T11
Tunnel Diode CR28 in a 7T11A

7T11

Navigation menu