4S2: Difference between revisions
No edit summary |
No edit summary |
||
| Line 27: | Line 27: | ||
Tek 4s2a sampler.png|42SA sampler schematic | Tek 4s2a sampler.png|42SA sampler schematic | ||
Tek 4s2a pulse gen.png|42SA pulse generator schematic | Tek 4s2a pulse gen.png|42SA pulse generator schematic | ||
Tek 4s2 ac amplifier outside.jpg | Tek 4s2 ac amplifier outside.jpg|AC Amplifier | ||
Tek 4s2 ac amplifier components.jpg | Tek 4s2 ac amplifier components.jpg|AC Amplifier | ||
Tek 4s2 memory outside.jpg | Tek 4s2 memory outside.jpg|Memory | ||
Tek 4s2 memory components.jpg | Tek 4s2 memory components.jpg|Memory | ||
Tek 4s2 inverter outside.jpg|Inverter | |||
Tek 4s2 inverter components.jpg|Inverter | |||
</gallery> | </gallery> | ||
[[Category:661 plugins]] | [[Category:661 plugins]] | ||
[[Category:Sampling plugins]] | [[Category:Sampling plugins]] | ||
Revision as of 20:07, 14 December 2017
Template:Plugin Sidebar 2 The Tektronix 4S2 is a two-channel sampling vertical plug-in for the 661. Signals enter the 4S2 through GR-874 connectors on the front panel. Unlike the 4S1, the 4S2's signal path does not contain a delay line between the input connector and the sampler. This has the advantage of maintaining higher pulse fidelity and thus higher bandwidth. It has the disadvantage of making it impossible to see the leading edge of the triggering event unless a pre-trigger is used.
The 4S2 uses a four-diode sampling bridge. The 4S2A uses a two-diode sampling bridge. This design change is discussed in the 4S2A Engineering Spec document linked below.
Pictures
-
-
-
-
-
42SA sampler schematic
-
42SA pulse generator schematic
-
AC Amplifier
-
AC Amplifier
-
Memory
-
Memory
-
Inverter
-
Inverter
