H: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 8: | Line 8: | ||
Type 53/54H was [[introduced in 1958]], along with the [[533]] and [[543]], renamed Type H in 1959, and dropped after 1970. | Type 53/54H was [[introduced in 1958]], along with the [[533]] and [[543]], renamed Type H in 1959, and dropped after 1970. | ||
* [http://w140.com/tek_type_h_schematics.pdf Tektronix Type H Schematics (PDF)] | * [http://w140.com/tek_type_h_ocr.pdf Tektronix Type H Manual (PDF)] | ||
* [http://w140.com/tek_type_h_schematics.pdf Tektronix Type H Schematics Only (PDF)] | |||
* [http://w140.com/tek_fcp/tek_type_h_factory_cal_proc.pdf Tektronix Type H Factory Calibration Procedure (PDF)] | * [http://w140.com/tek_fcp/tek_type_h_factory_cal_proc.pdf Tektronix Type H Factory Calibration Procedure (PDF)] | ||
Revision as of 09:44, 17 November 2012
The Tektronix Type H is a single-channel plug-in for 500-series scopes. It provides two inputs and has a switch to select between them. The rise time of the plug-in is 20 nanoseconds; bandwidth is 15MHz. The sensitivity ranges from 5mV/cm to 20V/cm. A compromise, Type H is not as fast as Type B, but it is DC-coupled on all ranges. Later Type H's use a turret attenuator. Type H with S/N less than 10,000 have ordinary attenuator.
Type 53/54H was introduced in 1958, along with the 533 and 543, renamed Type H in 1959, and dropped after 1970.
- Tektronix Type H Manual (PDF)
- Tektronix Type H Schematics Only (PDF)
- Tektronix Type H Factory Calibration Procedure (PDF)
Manual needed (complete).
