EIP 101A

Template:Plugin Sidebar 2 The EIP 101A is a Spectrum Analyzer plug-in, designed to work in all Tektronix oscilloscope mainframes which accept letter-type plug-ins. Used in the 201A power supply unit, it works together with all analog oscilloscopes. It covers the frequency range of 0.7-15GHz in one single band (tuned YIG bandpass design).

Key Specifications

• please add

Frequency Coverage 1-12.4 GHz (useable . 7 - 15.7 GHz) * Dial Frequency Accuracy 10 MHz +, 3% ** '- Selectable Video Bandwidths 1 KHz, 100 KHz, 3 MHz Frequency Response + 2 dB typical, ±4 dB maximum No. of Bands Required to Cover Frequency Range 1 Calibrated Dispersion 0 - 11. 4 GHz (useable 0 - 15. 0 GHz) Dispersion Resettability Typical 10MHz Dispersion Dial Accuracy Typical 10 MHz or ±. 5% whichever is greater Preselection 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down*** Resolution Typicall5 MHz Image Rejection Generates no image signals Intermod Rejection Intermod signals are reduced by the preselector selectivity over conventional microwave diode response Type of Receiver Crystal linear or log video with sweeping YIG pre selector Sensitivity (1 KHz Bandwidth) -45 dBm minimum Max. Input Power +20 dBm Limiting Level (2dB compression) . 7 - 1. 0 GHz -20 dBm typical 1. 0 - 1. 2 GHz >+5 dBm 1. 2 - 15.7 GHz >+10 dBm Log Accuracy (<1 MW Input) ± 1 dB Typical Variable Vertical Log Scale (dB/cm) Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm

Log Video Out Voltage 0.02 Volts/dB typical

Sweep Rate 1, 10, 30 Hz

Required Assoc. Equipment Scope or other analog display Plug-In' s available for : Tektronix which accept letter series plug-ins

• Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz.
  • If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis.
    • Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response.

Pictures

• 
• 
• 
• 
• 
• 
• 
• 
• 
•