82: Difference between revisions
No edit summary |
No edit summary |
||
Line 6: | Line 6: | ||
<gallery> | <gallery> | ||
Image:82_front.jpg|Front view. | Image:82_front.jpg|Front view, early style. | ||
Image:82_left.jpg|Left view. | Image:82_left.jpg|Left view. | ||
Image:82_top.jpg|Top view. | Image:82_top.jpg|Top view. | ||
Image:82_right.jpg|Right view. | Image:82_right.jpg|Right view. | ||
Image:Type 82 top.jpg | |||
Image:Type 82 rear.jpg | |||
Image:Type 82 leftb.jpg | |||
Image:Type 82 front.jpg|Front view, later style. | |||
Image:Type 82 bottom.jpg | |||
Image:Type 82 distamp bottom.jpg|Bottom of distributed amplifier. | |||
Image:Type 82 distamp top.jpg|Top of distributed amplifier. | |||
</gallery> | </gallery> |
Revision as of 20:46, 7 May 2010
The Tektronix Type 82 is a dual-trace plug-in for the 585 and 585A oscilloscopes. The Type 82 combined with a 585 or 585A provides a 4 nanosecond risetime. The front end of the Type 82 is a 7586 nuvistor cathode-follower, followed by bipolar diff-amps and diode channel switching, followed by a distributed output amplifier made of three 6DJ8 tubes, with differential 93-ohm outputs. The use of a distributed amplifier in a plug-in is unusual. Note that the 58x series differs from other 500-series scopes mainly in the fact the vertical signal interface between the plug-in and the mainframe is a low controlled impedance (93 ohms), as opposed to other 500-series scopes that present a high impedance to the plug-in.
-
Front view, early style.
-
Left view.
-
Top view.
-
Right view.
-
-
-
-
Front view, later style.
-
-
Bottom of distributed amplifier.
-
Top of distributed amplifier.