W

Template:Plugin Sidebar 2 The Tektronix Type W is a differential comparator plug-in amplifier for 500-series scopes. Its bandwidth varies from 23 MHz to 8 MHz depending on gain. Type W is faster than its Type Z predecessor, and it extends performance in terms of sensitivity, reaching 1 mV/div. It achieves 20,000 to 1 common-mode rejection at DC and low frequencies. It was designed by John Horn.

Type W has two signal inputs, "A" and "B", and a built in precision variable voltage supply, "V_C", which is controlled by a ten-turn pot and can vary from either −1.1 V to +1.1 V or −11 V to +11 V. A mode switch selects between displaying A−V_C, A−B, or V_C−B. The "A−B" mode is particularly useful for displaying the current in a sense resistor, while the other modes provide "slideback" measurements of small variations superimposed on a large constant. An output of V_C is provided on the front panel for precision measurements.

Unlike the Type Z, Type W has two gain axes: a decade attenuator and a 1−2−5−10−20−50 selector, reminiscent of Type D from ten years before.

Type W is the only letter-series plug-in with an "infinite resistance" input mode selectable at the front panel. (Type 1A5 has an internal jumper that can be cut.)

Original production uses a pair of type 8056 Nuvistors in the front end; starting at serial number 7000 these were replaced with JFETs.

In the letter-series timeline of differential comparators, Type W, introduced in 1965, follows Type Z and precedes Type 1A5.

In 1971, at serial number 7000, Type W was converted to FET input to reduce drift. Modification kit 040-0590-00 was offered to retrofit existing instruments.

Specifications

please add

Pictures

• 

  Front view.

• 

  Top-left view.

• 

  Bottom view.

• 

  Block Diagram

• 

  Differential Comparator

• 

  Input Attenuators

• 

  Switching Diagram

• 

  A-phase (prototype) Type W

• 

  A-phase (prototype) Type W

• 

  A-phase (prototype) Type W

• 

  A-phase (prototype) Type W

• 

  A-phase (prototype) Type W