THS720: Difference between revisions

From TekWiki
Jump to navigation Jump to search
mNo edit summary
(Added info, firmware and pictures)
Line 25: Line 25:
* [[Media:070-9750-02.pdf|THS720A MOD NV TekScope Component-Level Information Package 070-9750-02]]
* [[Media:070-9750-02.pdf|THS720A MOD NV TekScope Component-Level Information Package 070-9750-02]]
* [[Media:THS7XXAPDiag.pdf|THS700 Schematics]]
* [[Media:THS7XXAPDiag.pdf|THS700 Schematics]]
* [[Media:070-9785-03.pdf|WaveStar Software User Manual 070-9785-03]]


* [[Media:3MW-10566-6.pdf|Tektronix THS700 Series Product Brochure (2006)]]
* [[Media:3MW-10566-6.pdf|Tektronix THS700 Series Product Brochure (2006)]]
Line 60: Line 61:
Note that the differential signal layout for channel 2 is not as good as channel 1
Note that the differential signal layout for channel 2 is not as good as channel 1
since one side of channel 2 goes through 2 vias not found on channel 1.
since one side of channel 2 goes through 2 vias not found on channel 1.
==Included Accessories==
* P6113B - 10X, 100 MHz, CAT II, 300 V<sub>RMS</sub> Passive probes (THS710STD, THS720STD)
* P6117 - 10X, 200 MHz, CAT II, 300 V<sub>RMS</sub> Passive probes (THS730A, THS720A, THS710A)
* P5102 - 10X, 100 MHz, CAT II, 1000 V<sub>RMS</sub> Passive probes (THS720P)
* 012-1482-00 - Meter lead set
* THS7BAT - 4.8 V, 2.8 Ahr Ni-Cd Battery pack
* AC Power Adapter
** 119-4812-XX - North America
** 119-4813-XX - Universal European
** 119-4922-XX - United Kingdom
** 119-4923-XX - Japan
* 012-1364-00 - 2m RS-232 cable (8p8c RJ45 'console cable')
* 103-0403-00 - 9-pin adapter (8p8c RJ45 to DB-9 adapter)
* 016-1399-00 - Soft case
* 070-9247-XX - User manual (THS710STD, THS720STD)
* 070-9731-XX - User manual (THS730A, THS720P, THS720A, THS710A)
* 070-9257-XX - Reference manual (THS710STD, THS720STD)
* 070-9741-XX - Reference manual (THS730A, THS720P, THS720A, THS710A)
==Optional Accessories==
* P5102 - 10X, 100MHz, CAT II, 1000 V<sub>RMS</sub> Passive probes (THS730A, THS720A, THS710A, THS710STD, THS720STD)
* 012-1483-00 - Deluxe meter lead set (THS710STD, THS720STD)
* ATLDX1 - Deluxe meter lead set (THS730A, THS720P, THS720A, THS710A)
* THS7CHG - Battery charger
* THS7BAT - Extra 4.8 V, 2.8 Ahr Ni-Cd Battery pack
* 103-0090-00 - BNC to banana jack adapter to convert external trigger input to BNC (THS730A, THS720P, THS720A, THS710A)
* 174-1734-00 - Cigarette lighter adapter
* HC 411 - Thermal printer (006-7580-00 - Pack 5 paper rolls)
* THS7HCA - Hard carrying case
* A621 - BNC Current Probe, AC only, 2000 A max, 5Hz to 50 kHz
* A622 - BNC Current Probe, AC or DC, 100 A max, DC to 100 kHz
* A605 - DMM busbar-style current probe, AC only, 500A max, 48 Hz to 1 kHz, 1 mV/A
* A610 - DMM busbar-style current probe, AC or DC, 500A max, DC to 440 Hz, 1 mV/A
* P6129B - 1X-10X, 10 MHz/100 MHz Switchable passive probes
* P6561AS - 10X, 100 MHz SMD probes
* P6408 Word Recogniser Trigger Probes - 16-bit word recogniser probe (trigger event recognition only)
* S60DWAV - DocuWave DOS software (THS710STD, THS720STD)
* WSTR31 - WaveStar software (THS730A, THS720P, THS720A, THS710A)
* 070-9245-XX - Programmer manual (THS710STD, THS720STD)
* 070-9751-XX Programmer manual (THS730A, THS720P, THS720A, THS710A)
* 070-9246-XX - Service manual (THS710STD, THS720STD)
* 070-9752-XX - Service manual  (THS730A, THS720P, THS720A, THS710A)
==Software==
* [[Media:Wavestar_2012.05.09.11.07.29_16456_EN.zip|Tektronix Wavestar 2012.05.09.11.07.29 16456 EN 066-0934-03]] (ZIP, 102MB) ''Product Key: WSTRO618650124''
* [[Media:Docuwave_1.2.zip|Docuwave 1.2 for DOS]] (ZIP, 704 KB)
==Firmware==
* [[Media:THS720_v1.03_Firmware.zip|THS720STD v1.03 Firmware]] (ZIP)
* [[Media:THS720_v1.08_Firmware.zip|THS720STD v1.08 Firmware]] (ZIP)
* [[Media:THS710A_v1.11_Firmware.zip|THS710A v1.11 Firmware]] (ZIP)
* [[Media:THS720x_v1.16_Firmware.zip|THS720A, THS720P v1.16 Firmware]] (ZIP)


==Pictures==
==Pictures==
Line 91: Line 145:
THS720P_PCB_Top.jpg|THS720P Top of Main PCB
THS720P_PCB_Top.jpg|THS720P Top of Main PCB
THS720P_PCB_Bottom.jpg|THS720P Back of Main PCB
THS720P_PCB_Bottom.jpg|THS720P Back of Main PCB
</gallery>
'''Accessories'''
<gallery>
THS7CHG.jpg|Battery Charger
THS7CHG_Internal.jpg|Battery Charger Internal
</gallery>
</gallery>


[[Category:THS series scopes]]
[[Category:THS series scopes]]

Revision as of 08:15, 20 April 2023

Tektronix THS720
100 MHz 2-ch portable digital scope
Tektronix THS720

Produced from (?) to (?)

Manuals
Manuals – Specifications – Links – Pictures

The Tektronix THS720 is a portable 100 MHz, 500 MS/s (each channel) dual-channel digital oscilloscope with isolated inputs. There were two variants, the THS720 STD and the THS720A. The primary difference is that the THS720A will trigger from the DMM input.

The THS720P includes features for electrical/power electronics measurements.

THS700 series high voltage isolated front end design was done by Murlan Kaufman.

Key Specifications

  • please add

Operation

Due to the isolated inputs, the probe ground must be connected even when compensating the probes with the "PROBE COMP" output. It can be used with any BNC probe but the scale factor pin found on many Tektronix probes is not used. The vertical menu has a scale factor entry (1×, 10×, 100×, 1000×) which can also be used for direct BNC inputs.

Recommended probes are the P5102 and the P6113B, both are 10× probes with protected grounds for isolated measurements. The P5102 has the best isolation, allowing 600 V between reference ground and earth ground.

Internals

Primary microprocessor is the Motorola/Freescale MC68331CFC16. An Intel E28F008SA120 Flash Memory chip is used for setup, cal and waveform storage. The switching power supply is run by a TL1451A, a TI two channel boost/buck controller. The DMM is a 3¾-digit Maxim MAX134CQH.

The analog scope section starts with an attenuator hybrid driven by four channels of HP (now Avago) optoisolators and NEC relays. The hybrid contains the AC coupling capacitor and many laser trimmed resistors along with a custom Tek 165-2545-00 BGA. The signal then passes through a single-ended to differential transformer and goes to a custom labeled Maxim two-channel high speed A/D converter 234-1503-20. Note that the differential signal layout for channel 2 is not as good as channel 1 since one side of channel 2 goes through 2 vias not found on channel 1.

Included Accessories

  • P6113B - 10X, 100 MHz, CAT II, 300 VRMS Passive probes (THS710STD, THS720STD)
  • P6117 - 10X, 200 MHz, CAT II, 300 VRMS Passive probes (THS730A, THS720A, THS710A)
  • P5102 - 10X, 100 MHz, CAT II, 1000 VRMS Passive probes (THS720P)
  • 012-1482-00 - Meter lead set
  • THS7BAT - 4.8 V, 2.8 Ahr Ni-Cd Battery pack
  • AC Power Adapter
    • 119-4812-XX - North America
    • 119-4813-XX - Universal European
    • 119-4922-XX - United Kingdom
    • 119-4923-XX - Japan
  • 012-1364-00 - 2m RS-232 cable (8p8c RJ45 'console cable')
  • 103-0403-00 - 9-pin adapter (8p8c RJ45 to DB-9 adapter)
  • 016-1399-00 - Soft case
  • 070-9247-XX - User manual (THS710STD, THS720STD)
  • 070-9731-XX - User manual (THS730A, THS720P, THS720A, THS710A)
  • 070-9257-XX - Reference manual (THS710STD, THS720STD)
  • 070-9741-XX - Reference manual (THS730A, THS720P, THS720A, THS710A)

Optional Accessories

  • P5102 - 10X, 100MHz, CAT II, 1000 VRMS Passive probes (THS730A, THS720A, THS710A, THS710STD, THS720STD)
  • 012-1483-00 - Deluxe meter lead set (THS710STD, THS720STD)
  • ATLDX1 - Deluxe meter lead set (THS730A, THS720P, THS720A, THS710A)
  • THS7CHG - Battery charger
  • THS7BAT - Extra 4.8 V, 2.8 Ahr Ni-Cd Battery pack
  • 103-0090-00 - BNC to banana jack adapter to convert external trigger input to BNC (THS730A, THS720P, THS720A, THS710A)
  • 174-1734-00 - Cigarette lighter adapter
  • HC 411 - Thermal printer (006-7580-00 - Pack 5 paper rolls)
  • THS7HCA - Hard carrying case
  • A621 - BNC Current Probe, AC only, 2000 A max, 5Hz to 50 kHz
  • A622 - BNC Current Probe, AC or DC, 100 A max, DC to 100 kHz
  • A605 - DMM busbar-style current probe, AC only, 500A max, 48 Hz to 1 kHz, 1 mV/A
  • A610 - DMM busbar-style current probe, AC or DC, 500A max, DC to 440 Hz, 1 mV/A
  • P6129B - 1X-10X, 10 MHz/100 MHz Switchable passive probes
  • P6561AS - 10X, 100 MHz SMD probes
  • P6408 Word Recogniser Trigger Probes - 16-bit word recogniser probe (trigger event recognition only)
  • S60DWAV - DocuWave DOS software (THS710STD, THS720STD)
  • WSTR31 - WaveStar software (THS730A, THS720P, THS720A, THS710A)
  • 070-9245-XX - Programmer manual (THS710STD, THS720STD)
  • 070-9751-XX Programmer manual (THS730A, THS720P, THS720A, THS710A)
  • 070-9246-XX - Service manual (THS710STD, THS720STD)
  • 070-9752-XX - Service manual (THS730A, THS720P, THS720A, THS710A)

Software

Firmware

Pictures

THS720

  • THS720STD Displaying probe compensation waveform

    THS720STD Displaying probe compensation waveform

  • THS720STD Top of Main PCB

    THS720STD Top of Main PCB

  • THS720STD Back of Main PCB

    THS720STD Back of Main PCB

  • THS720STD Attenuator with cover removed

    THS720STD Attenuator with cover removed

  • THS720STD Operation without case

    THS720STD Operation without case

THS720A

THS720P

  • THS720P Top of Main PCB

    THS720P Top of Main PCB

  • THS720P Back of Main PCB

    THS720P Back of Main PCB

Accessories

  • Battery Charger

    Battery Charger

  • Battery Charger Internal

    Battery Charger Internal

Retrieved from "https://w140.com/tekwiki/index.php?title=THS720&oldid=81330"