11A-series plug-in NVRAM replacement: Difference between revisions

11A-series plug-in NVRAM replacement (view source)

6 bytes added , 13 February 2019

transitory commit, not complete

32,014

edits

@@ Line 36: / Line 36: @@
 except for 12 additional constants required by the 11A52.
-'''Note''': The 12 calibration constants for 11A52 high frequency transient response cannot be set using an 11300 series mainframe.
+'''Note''': The 12 calibration constants for 11A52 high frequency transient response
-This is apparently due to a failure of the plugin design group and the 11300 series design group to communicate
+cannot be set using an 11300 series mainframe.
-in spite of the fact that the two groups were contiguous and had the same manager.
+This is apparently due to a failure of the plug-in design group and the 11300 series design group
+to communicate in spite of the fact that the two groups were contiguous and had the same manager.
 When given a choice, do not use an 11401 main frame for setting the 11A52 high frequency calibration constants
-as the 11401 bandwidth is not quite adequate to adjust the 11A52 properly, although you can probably come pretty close.
+as the 11401 bandwidth is not quite adequate to adjust the 11A52 properly,
+although you can probably come pretty close.
 The DSA601 mainframe can be used as well as the 11402 and 11403.
-For all plugins, you must enter a serial number into the NVRAM using an 11000 series mainframe,
+For all plug-ins, you must enter a serial number into the NVRAM using an 11000 series mainframe,
 a personal computer and either an RS232C cable or GPIB cable connected between them.