37
edits
EIP 101A: Difference between revisions
Jump to navigation
Jump to search
no edit summary
No edit summary |
No edit summary |
||
| (16 intermediate revisions by the same user not shown) | |||
| Line 2: | Line 2: | ||
title=EIP 101A | | title=EIP 101A | | ||
summary=Microwave Spectrum Analyzer plug-in | | summary=Microwave Spectrum Analyzer plug-in | | ||
image= | image=EIP101A_faceplate.jpg | | ||
caption=EIP 101A Microwave Spectrum Analyzer plug-in | | caption=EIP 101A Microwave Spectrum Analyzer plug-in | | ||
series=[[500-series scopes]] | | series=[[500-series scopes]] | | ||
| Line 8: | Line 8: | ||
discontinued=(?) | | discontinued=(?) | | ||
manuals= | manuals= | ||
* | * [[Media:EIP 101A_201A_Ops_Svc.pdf|EIP 101A Operation and Instruction Manual w/schematics]] | ||
}} | }} | ||
The '''EIP 101A''' is a Spectrum Analyzer plug-in, designed to work in all Tektronix oscilloscope mainframes which accept letter-type plug-ins. Used in the 201A power supply unit, it works together with all analog oscilloscopes. It covers the frequency range of 0.7- | The '''EIP 101A''' is a receiver-type Spectrum Analyzer plug-in, designed to work in all Tektronix oscilloscope mainframes which accept letter-type plug-ins. Used in the 201A power supply unit, it works together with all analog oscilloscopes. It covers the frequency range of 0.7 - 15 GHz in one single band and comprises a three-resonator YIG preselector. | ||
{{ | {{BeginSpecs}} | ||
{{Spec | Frequency Coverage | 1 - 12.4 GHz (useable 0.7 - 15.7 GHz)* }} | |||
{{Spec | Dial Frequency Accuracy | 10 MHz +/-3% ** }} | |||
{{Spec | Selectable Video Bandwidths | 1 KHz, 100 KHz, 3 MHz }} | |||
{{Spec | Frequency Response | + 2 dB typical, ±4 dB maximum }} | |||
{{Spec | Calibrated Dispersion | 0 - 11.4 GHz (useable 0 - 15.0 GHz) }} | |||
{{Spec | No. of Bands Required to Cover Frequency Range | 1 }} | |||
{{Spec | Dispersion Resettability | Typical 10 MHz }} | |||
{{Spec | Dispersion Dial Accuracy | Typical 10 MHz or ±0.5% whichever is greater }} | |||
{{Spec | Preselection | 3 Resonator YIG filter, nominal 3 dB bandwidth 15 MHz, straight thru leakage >60 dB down, tracking spurious typically >45 dB down*** }} | |||
{{Spec | Resolution | Typical 15 MHz }} | |||
{{Spec | Image Rejection | Generates no image signals }} | |||
{{Spec | Intermod Rejection | Intermod signals are reduced by the preselector selectivity over conventional microwave diode response }} | |||
{{Spec | Type of Receiver | Crystal linear or log video with sweeping YIG pre selector }} | |||
{{Spec | Sensitivity (1 KHz Bandwidth) | -45 dBm minimum }} | |||
{{Spec | Max. Input Power | +20 dBm }} | |||
{{Spec | Limiting Level (2dB compression) | 0.7 - 1.0 GHz -20 dBm typical }} | |||
{{Spec | | 1.0 - 1.2 GHz >+5 dBm }} | |||
{{Spec | | 1.2 - 15.7 GHz >+10 dBm }} | |||
{{Spec | Log Accuracy (<1 MW Input) | ± 1 dB Typical }} | |||
{{Spec | Variable Vertical Log Scale (dB/cm) | Variable and calibratable with internal calibrate signal over the range of 2 dB/cm to 20 dB/cm }} | |||
{{Spec | Log Video Out Voltage | 0.02 Volts/dB typical }} | |||
{{Spec | Sweep Rate | 1, 10, 30 Hz }} | |||
{{Spec | Required Assoc. Equipment | Scope or other analog display }} | |||
{{Spec | Plug-In' s available for: | Tektronix which accept letter series plug-ins }} | |||
{{Spec | | * Usable frequency coverage is limited by the center frequency dial indicator with the unit set on a center frequency of 12 GHz and dispersion set for 15 GHz, most units will display signals as high as 18 GHz. | }} | |||
{{Spec | | ** If setting is always approached from 700 MHz, if not, add 5 - 15 MHz for hysteresis. | }} | |||
{{Spec | | *** Tracking spurious is a second pass band response, always located a fixed number of MHz (approximately 200 MHz) above the normal preselector response. | }} | |||
{{EndSpecs}} | |||
==Links== | ==Links== | ||
| Line 26: | Line 60: | ||
EIP101A_bottom_view.jpg | EIP101A_bottom_view.jpg | ||
EIP101A_DC_block_and_Detector.jpg | EIP101A_DC_block_and_Detector.jpg | ||
EIP101A_gearbox.jpg | EIP101A_gearbox.jpg | ||
EIP101A_left side.jpg | EIP101A_left side.jpg | ||