565: Difference between revisions

108 bytes added ,  28 September 2014
no edit summary
No edit summary
No edit summary
Line 19: Line 19:


==Specifications==
==Specifications==
''please add''
The vertical characteristics are mostly determined by the vertical plug-ins. 


The fastest sweep is 1us/div (100ns/div with 10x horizontal magnification enabled).  The sweep delay can be adjusted over a range from 10 microseconds to 50 seconds.
Power consumption, including plug-ins, is about 600 watts, maximum.
The internal calibrator produces a 1 kHz square wave with amplitude selectable in decade steps from 1 mV to 100 V.
==Circuits==
==Circuits==
The 565 uses the [[T5650]] CRT.
The 565 uses the [[T5650]] CRT.
Line 40: Line 45:
and sent to "TRIGGER" switches.  From there, the trigger signal is sent through a [[6DJ8]]-based differential amplifier  
and sent to "TRIGGER" switches.  From there, the trigger signal is sent through a [[6DJ8]]-based differential amplifier  
and then is discriminated by a [[6DJ8]]-based Schmitt trigger.
and then is discriminated by a [[6DJ8]]-based Schmitt trigger.
 
 
The fastest sweep is 1us/div (100ns/div with 10x horizontal magnification enabled).  The sweep delay can be adjusted over a range from 10 microseconds to 50 seconds. 
 
The 565 is also unusual in that it employs a [[tunnel diodes|tunnel diode]] in the trace intensification circuit.  The tunnel diode forms as a bistable multivibrator: kick it one way and it turns on and stays on, kick it the other way and
The 565 is also unusual in that it employs a [[tunnel diodes|tunnel diode]] in the trace intensification circuit.  The tunnel diode forms as a bistable multivibrator: kick it one way and it turns on and stays on, kick it the other way and
it turns off and stays off.
it turns off and stays off.


=== Calibrator ===
=== Calibrator ===
The internal calibrator produces a 1 kHz square wave with amplitude selectable in decade steps from 1 mV to 100 V.
 
It is an astable multivibrator formed by one half of a [[12AT7]] and a [[6AU6]].
The calibrator is an astable multivibrator formed by one half of a [[12AT7]] and a [[6AU6]].
The other half of the 12AT7 serves as the output cathode follower for the calibrator.
The other half of the 12AT7 serves as the output cathode follower for the calibrator.


Line 91: Line 94:
[[Category:Dual beam scopes]]
[[Category:Dual beam scopes]]


[[Category:Specifications needed]]
[[Category:Introduced in 1963]]
[[Category:Introduced in 1963]]