444
edits
No edit summary |
|||
Line 3: | Line 3: | ||
==PS503A Manual== | ==PS503A Manual== | ||
There | There are errors in the circuit drawing: | ||
* All amplifiers are connected to +5 V or -5 V. In fact they are connected to the +6.2 V or -6.2 V supply. | |||
* R48 is missing on the grid location table. It is in F1. | |||
* Other parts are missing on the grid location table (Q25, ...) | |||
==PS503A: Instable Output/Output voltage is decreasing with time== | ==PS503A: Instable Output/Output voltage is decreasing with time== | ||
The output is instable (±100 mV) and is decreasing with time. | Problem: The output is instable (±100 mV) and is decreasing with time. | ||
The faulty part was C34 (4.7 µF/50 V). C34 stabilises the reference voltage. Measuring C34 with an RLC-meter shows no fault: 5.0 µF and a serial resistance of 5 Ω. The faulty behaviour of C34 can only be seen by applying a DC voltage (see picture). | Solution: The faulty part was C34 (4.7 µF/50 V). C34 stabilises the reference voltage. Measuring C34 with an RLC-meter shows no fault: 5.0 µF and a serial resistance of 5 Ω. The faulty behaviour of C34 can only be seen by applying a DC voltage (see picture). | ||
C34 is shorted by the output-on button. So, replacing C34 with a tantalum capacitor is not recommended. | C34 is shorted by the output-on button. So, replacing C34 with a tantalum capacitor is not recommended. | ||
==PS503A: Replacing the voltage indicator light bulb with a LED== | |||
to preserve the effect that the indicator lights up with higher output voltage, some resistor have to be changed. | |||
* R48 (+ output) and R148 (- output) limits the low current that will always flow when the output is ON. This current will flow at 0 V output voltage. (supplied by +33 V / -33 V) | |||
* R55 (+ output) and R155 (- output) limits the high current that will be added to the low current according to the output voltage. (supplied by the 0 to 20 V output voltage) | |||
* The LED should be pushed as deep as possible into the bulb holder, so it holds the yellow plastic window part in place. | |||
* Choose R48/R148 and R55/R155 according the chosen LED (LED current and power dissipation of the resistor) | |||
* R48 is missing on the grid location table. It is in F1. | |||
edits