2465: Difference between revisions

Revision as of 14:43, 30 April 2019

{{{manufacturer}}}

Portable 150/300 MHz 4-ch scope

Produced from 1984 to (?)

Manuals

(All manuals in PDF format unless noted otherwise)

Manuals – Specifications – Links – Pictures

The Tektronix 2465 is a four-channel 300 MHz portable oscilloscope. The 2445 is a 150 MHz version.

CRT is the 154-0850-01.

The 2465 is from the penultimate generation of analog Tektronix scopes.

The horizontal amplifier in the 2465 was designed by Art Metz and Ken Schlotzhauer. Art Metz also worked on the triggers. Art Metz and Walt Ainsworth designed the sweeps.

Options

Option 01 (DMM) added a 4½-digit, fully autoranging digital multimeter which measures DC and AC voltage and current, resistance, dBV, dBm, continuity, and temperature.
Option 05 (TV) added TV (back-porch) clamp circuitry to the Channel 2 input and TV trigger coupling modes, allowing selection of either horizontal or vertical sync pulses to obtain horizontal-line-sync or field-sync pulse triggering.
Option 06 (Counter/Timer/Trigger) allows precision time-interval measurement, event and frequency counting, delay-by-events triggering, and logic triggering.
Option 09 added option 06, the CTT, plus a 17-bit P6407 word recognizer probe.
Option 10 added a GPIB interface for remote control.
Option 11 added two probe-power connectors on the rear panel of the instrument. Only shown in the Tektronix catalogues for the 2465A (1987) and 2465B (1989)

Key Specifications

	— 2445 —
Bandwidth	150 MHz
	— 2465 —
Bandwidth	350 MHz
	— Common —
Sweep Rate	500 ps/div
Channels	Four independent channels
Vertical	2 mV/div vertical sensitivity
Cursors	Delta Volts and Delta Time Cursors
CRT Readout	Scale Factors, Trigger Level, Voltage, Time, Frequency, Phase and Ratio Measurements and Mode Indicators
Trigger	Advanced Triggering with "Hands Off" Auto Level Triggering
Trigger Bandwidth	500 MHz min.
Input Impedance	50 Ω/1 MΩ inputs with 50 Ω protection
Probes	Two P6131 ×10 probes, 1.3 m

Links

How to enter test mode

Pictures

2445

Prototype Knobless 2445 in VintageTEK Museum

2465

@@ Line 39: / Line 39: @@
 * Option 10 added a [[GPIB interface]] for remote control.
 * Option 11 added two [[LEMO S-series connector|probe-power connectors]] on the rear panel of the instrument.  Only shown in the Tektronix catalogues for the 2465A (1987) and 2465B (1989)
-* Option 46 is the designation for the military version of the scope (OS-288/G) that included option 10 IEEE-488 interface and 2 probes.
 {{BeginSpecs}}