|
|
| (3 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| * [https://www.youtube.com/watch?v=h5ZH7e3sXbo Tektronix PS503A Power Supply Restoration] by NFM @ YouTube | | * [https://www.youtube.com/watch?v=--AbTooK15s Tektronix PS503 and PS503A Dual Power Supply Repairs] by Bob Haas, VintageTEK Museum @ YouTube |
| | |
| | |
| ==PS503A Manual==
| |
| There are errors in the circuit drawing:
| |
| * All amplifiers are connected to +5 V or -5 V. In fact they are connected to the +6.2 V or -6.2 V supply.
| |
| * R48 is missing on the grid location table. It is in F1.
| |
| * Other parts are missing on the grid location table (Q25, ...)
| |
| | |
| ==PS503A: Instable Output/Output voltage is decreasing with time==
| |
| Problem: The output is instable (±100 mV) and is decreasing with time. <br>
| |
| Solution: The faulty part was C34 (4.7 µF/50 V). C34 stabilises the reference voltage. Measuring C34 with an RLC-meter shows no fault: 5.0 µF and a serial resistance of 5 Ω. The faulty behaviour of C34 can only be seen by applying a DC voltage (see picture).
| |
|
| |
| C34 is shorted by the output-on button. So, replacing C34 with a tantalum capacitor is not recommended.
| |
| | |
| ==PS503A: Replacing the voltage indicator light bulb with a LED==
| |
| to preserve the effect that the indicator lights up with higher output voltage, some resistor have to be changed.
| |
| * R48 (+ output) and R148 (- output) limits the low current that will always flow when the output is ON. This current will flow at 0 V output voltage. (supplied by +33 V / -33 V)
| |
| * R55 (+ output) and R155 (- output) limits the high current that will be added to the low current according to the output voltage. (supplied by the 0 to 20 V output voltage)
| |
| * The LED should be pushed as deep as possible into the bulb holder, so it holds the yellow plastic window part in place.
| |
| * Choose R48/R148 and R55/R155 according the chosen LED (LED current and power dissipation of the resistor)
| |
| * R48 is missing on the grid location table. It is in F1.
| |
| | |
| | |
| ==Pictures==
| |
| | |
| <gallery>
| |
| PS503A - Current C34.png|DC current thru C34 (12 V / 10 mA limit)
| |
| </gallery>
| |
| | |
| | |
|
| |
|
| [[Category:Instrument repair reports]] | | [[Category:Instrument repair reports]] |