Tekprobe SMA connector: Difference between revisions
No edit summary |
|||
| (One intermediate revision by one other user not shown) | |||
| Line 1: | Line 1: | ||
[[File:Tekprobe SMA.jpg | thumb | 300px | right | Input connector on [[TDS820]] scope]] | [[File:Tekprobe SMA.jpg | thumb | 300px | right | Input connector on [[TDS820]] scope]] | ||
[[File:P6209.jpg | thumb | 300px | right | P6209 probe]] | [[File:P6209.jpg | thumb | 300px | right | P6209 probe]] | ||
The '''Tekprobe SMA''' interface was used in 1990s Tektronix equipment, e.g. the [[TDS820]] series, to interface active probes (e.g. the [[P6207]]) to oscilloscopes. | The '''Tekprobe SMA''' interface was used in 1990s Tektronix equipment, e.g. the [[TDS820]] series, to interface active probes (e.g. the [[P6207]]) to high-bandwidth oscilloscopes. | ||
It uses an [[SMA connector]] for the signal and a separate multi-pin connector for probe power, identification and control. | It uses an [[SMA connector]] for the signal and a separate multi-pin connector for probe power, identification and control. | ||
| Line 15: | Line 15: | ||
* [[TDS820]] | * [[TDS820]] | ||
* [[TDS840]] | * [[TDS840]] | ||
| valign="top" | | | valign="top" | | ||
* [[P6206]] | * [[P6206]] | ||
Latest revision as of 15:02, 19 March 2024
The Tekprobe SMA interface was used in 1990s Tektronix equipment, e.g. the TDS820 series, to interface active probes (e.g. the P6207) to high-bandwidth oscilloscopes.
It uses an SMA connector for the signal and a separate multi-pin connector for probe power, identification and control.
A similar standard exists based on BNC connectors.
Used in
| Scopes | Probes |
|---|---|