S-4: Difference between revisions

Revision as of 16:52, 3 February 2018

Template:Plugin Sidebar 2 The Tektronix S-4 is a sampling head for 7000- and 3S-series samplers. It was designed by George Frye and introduced in 1968. It is the fastest of the S-series plug-in samplers.

Key Specifications

Rise time	25 ps (observed with S-50 or S-52, 35 ps)
Bandwidth	14.5 GHz
Input impedance	50 Ω (terminated SMA connector)
Input range	operating, 1 V_p-p; max. safe overload, ±5 V
Noise	< 5 mV
Features	trigger signal pick-off for internal triggering

Internals

The S-4 sampling gate is based upon a traveling wave trapped-charge transmission line in which the sampling window is set by the propagation time of a pulse edge through a thick-film transmission line. This technique requires only a sharp pulse edge rather than a precise pulse width, which is harder to generate. The sampling diodes are housed in a special coaxial connector that provides a high bandwidth signal path.

To disassemble the sampler hybrid, first remove it from the sampler board as per the manual. Remove the input connector using a 7/32" wrench and remove the 20 dB attenuator with small pliers. The ceramic board is held to the housing using roll pins that can be pressed out with a 0.030" pin punch. The hybrid has six diodes, each about 0.75mm square. The cathodes are glued to the gold substrate with conductive epoxy and the anodes are wire-bonded (twice) over a gap to the next step in the strobe line. It appears that a standard beam-lead diode may fit across the gap but cleanly removing a failed diode without damaging the substrate would be quite difficult.

Links

Pictures

Top view of the S4 plug-in
Left view
Right view
Schematic
Sampler board, strobe side
Sampler board, preamp side
Sampler board, disassembled with parts orientation
Microphotograph of sampler hybrid
S-4 in 7S11
S-4 in 7S11

@@ Line 12: / Line 12: @@
 * [http://w140.com/frye_s4_gate.pdf George Frye's Explanation of S-4 sampler in October 1968 Service Scope (PDF)]
 }}
-The '''Tektronix S-4''' is a sampling head for 7000- and 3S-series samplers.  It was designed by [[George Frye]] and [[introduced in 1968]]. It is the fastest of the S-series plug-in samplers.
+The '''Tektronix S-4''' is a sampling head for 7000- and 3S-series samplers.
+It was designed by [[George Frye]] and [[introduced in 1968]].
+It is the fastest of the S-series plug-in samplers.
 {{BeginSpecs}}