507: Difference between revisions
No edit summary |
No edit summary |
||
| Line 39: | Line 39: | ||
<gallery> | <gallery> | ||
Tek 507.jpg|507 on Cart | |||
Tek 507 and ps.jpg|507 with Power Supply | |||
Tek 507 at general electric.jpg|507 at General Electric | |||
Tek 507 block diagram.png|Block Diagram | |||
Tek 507 sweep trigger and trip pulse.png|Sweep Trigger and Trip Pulse | |||
Tek 507 time mark generator.png|Time Mark Generator | |||
Tek 507 vertical deflection.png|Vertical Deflection | |||
Tek 507 horizontal amp.png|Horizontal Amplifier | |||
Tek 507 crt circuit.png|CRT Circuit | |||
Tek_507_heater_wiring.png|Heater Wiring | |||
Tek 507 power supply.png|Power Supply | |||
Tek 507 ps 1.jpg | Tek 507 ps 1.jpg | ||
Tek 507 ps 2.jpg | Tek 507 ps 2.jpg | ||
Revision as of 15:19, 3 February 2018
The Tektronix Type 507 was designed for the power industry for surge testing. It was introduced in 1959.
The scope was intended to operate in an environment of strong electromagnetic fields. It does not take plug-ins. The power supply is external, like in the 517, 551, and 555.
The vertical signal path of the 507 does not contain amplifiers. It has a 5 nanosecond risetime. The input impedance of the 507 is 72 Ω. The maximum sensitivity is deliberately low, at 50 V/cm.
The input attenuator is very unusual for Tek scopes. It is a switch with ten positions in "% of signal", where each step is 10%. The deflection signal is permanently AC-coupled and, unusually, the DC blocking capacitor is after the input attenuator.
The 507 has 20 kV of post-deflection acceleration, produced by four 1X2 tubes. The lower-voltage power supplies, located in the external box, are all tube except for selenium rectifiers for some of the lower voltages.
The 507 uses the T507 CRT.
Links
- Service Scope No. 18, Feb 1963: Anode-Connector Arcing in the Type 507 Oscilloscope
Pictures
-
507 on Cart
-
507 with Power Supply
-
507 at General Electric
-
Block Diagram
-
Sweep Trigger and Trip Pulse
-
Time Mark Generator
-
Vertical Deflection
-
Horizontal Amplifier
-
CRT Circuit
-
Heater Wiring
-
Power Supply
-
-
-
-
-
-
-
-
-
-
-
-
