Tekprobe SMA connector: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
mNo edit summary |
||
| Line 1: | Line 1: | ||
[[File:Tekprobe SMA.jpg | thumb | 300px | right | Input connector on [[TDS820]] scope]] | [[File:Tekprobe SMA.jpg | thumb | 300px | right | Input connector on [[TDS820]] scope]] | ||
[[File:P6209.jpg | thumb | 300px | right | P6209 probe]] | [[File:P6209.jpg | thumb | 300px | right | P6209 probe]] | ||
The '''Tekprobe SMA''' interface was used in 1990s Tektronix equipment, e.g. the [[TDS820]] series, to interface active probes (e.g. the [[P6207]]) to oscilloscopes. | The '''Tekprobe SMA''' interface was used in 1990s Tektronix equipment, e.g. the [[TDS820]] series, to interface active probes (e.g. the [[P6207]]) to high-bandwidth oscilloscopes. | ||
It uses an [[SMA connector]] for the signal and a separate multi-pin connector for probe power, identification and control. | It uses an [[SMA connector]] for the signal and a separate multi-pin connector for probe power, identification and control. | ||
Revision as of 08:01, 29 September 2018
The Tekprobe SMA interface was used in 1990s Tektronix equipment, e.g. the TDS820 series, to interface active probes (e.g. the P6207) to high-bandwidth oscilloscopes.
It uses an SMA connector for the signal and a separate multi-pin connector for probe power, identification and control.
A similar standard exists based on BNC connectors.
Used in
| Scopes | Probes |
|---|---|