T: Difference between revisions
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
manuals= | manuals= | ||
* [[Media:070-337.pdf|Tektronix Type T Manual (PDF)]] | * [[Media:070-337.pdf|Tektronix Type T Manual (PDF)]] | ||
* [http://w140.com/tek_fcp/tek_type_t_factory_cal_proc.pdf Tektronix Type T Factory Calibration Procedure (PDF)] | <!-- * [http://w140.com/tek_fcp/tek_type_t_factory_cal_proc.pdf Tektronix Type T Factory Calibration Procedure (PDF)] --> | ||
* [[Media:tek_type_t_fcp.pdf|Tektronix Type T Factory Calibration Procedure (PDF, OCR)]] | * [[Media:tek_type_t_fcp.pdf|Tektronix Type T Factory Calibration Procedure (PDF, OCR)]] | ||
}} | }} | ||
Revision as of 15:22, 14 October 2018
Template:Plugin Sidebar 2 The Tektronix Type T is a timebase plug-in primarily intended for use in the 536 X-Y scope. It contains trigger and sweep circuitry. The typical use of a Type T plug-in is as the X-axis plug-in in a 536, to make the 536 behave like a normal oscilloscope instead of an X-Y scope. However, there is no capability for internal triggering – a jumper must be connected from the Vertical Signal Out on the 536 to the External Trig on the Type T.
Plugging a Type T in a vertical slot of a normal 500-series scope produces a raster, and using the scope's Z-axis input this allows a crude video display.
The banana jack on the back of the plugin is to provide retrace blanking when used in the horizontal slot of a 536
The Type T was introduced in 1957 and dropped after 1972, the same as its primary host, the 536. (Types K, L, and T are tied for longest production life, at 16 years, B, D, and G are next at 15 years.)
Pictures
-
Front view
-
Catalog image
-
front
-
left side
-
top view
-
bottom view
-
read panel
-
top view
-
bottom view
-
Trigger schematic
-
Timebase schematic
